blob: 30d1457638a8115a5c954a763a6d19bbee13252b (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
|
#
# USB Host Controller Drivers
#
comment "USB Host Controller Drivers"
config USB_XHCI_HCD
bool "xHCI HCD (USB 3.0) support"
---help---
The eXtensible Host Controller Interface (xHCI) is standard for USB 3.0
"SuperSpeed" host controller hardware.
config USB_XHCI
bool
default USB_XHCI_HCD
---help---
TODO: rename after most boards switch to Kconfig
if USB_XHCI_HCD
endif
config USB_EHCI_HCD
bool "EHCI HCD (USB 2.0) support"
---help---
The Enhanced Host Controller Interface (EHCI) is standard for USB 2.0
"high speed" (480 Mbit/sec, 60 Mbyte/sec) host controller hardware.
If your USB host controller supports USB 2.0, you will likely want to
configure this Host Controller Driver.
EHCI controllers are packaged with "companion" host controllers (OHCI
or UHCI) to handle USB 1.1 devices connected to root hub ports. Ports
will connect to EHCI if the device is high speed, otherwise they
connect to a companion controller. If you configure EHCI, you should
probably configure the OHCI (for NEC and some other vendors) USB Host
Controller Driver or UHCI (for Via motherboards) Host Controller
Driver too.
You may want to read <file:Documentation/usb/ehci.txt>.
config USB_EHCI
bool
default USB_EHCI_HCD
---help---
TODO: rename after most boards switch to Kconfig
if USB_EHCI_HCD
config USB_EHCI_UNIPHIER
bool "Support for Panasonic UniPhier on-chip EHCI USB controller"
depends on ARCH_UNIPHIER
default y
---help---
Enables support for the on-chip EHCI controller on Panasonic
UniPhier SoCs.
endif
|
