| Commit message (Expand) | Author | Age | Lines |
* | MLK-11718-2: mtd: nand: change the BCH layout setting for large oob NAND | Han Xu | 2015-10-15 | -23/+113 |
* | MLK-10740: add maximum ecc platfrom can support | Han Xu | 2015-05-07 | -1/+7 |
* | MLK-10385-2 imx: nand: Update GPMI NAND driver to support MX7D | Ye.Li | 2015-04-29 | -1/+1 |
* | MLK-10178-10 mtd:nand:mxs fix potential dcache issue | Peng Fan | 2015-04-29 | -1/+7 |
* | MLK-10035-2: supports NAND chips with oob size up to 744 byte | Allen Xu | 2015-04-29 | -8/+14 |
* | ENGR00315894-33 gpmi: use the same ECC strength as used in the kernel | Ye.Li | 2015-04-29 | -19/+13 |
* | lpc32xx: mtd: nand: add MLC NAND controller | Albert ARIBAUD \(3ADEV\) | 2015-04-10 | -0/+765 |
* | Merge branch 'master' of git://git.denx.de/u-boot-atmel | Tom Rini | 2015-03-31 | -0/+6 |
|\ |
|
| * | ARM: at91: atmel_nand: Support flash based BBT | David Dueck | 2015-04-01 | -0/+6 |
* | | mtd: vf610_nfc: specify transfer size before each transfer | Stefan Agner | 2015-03-30 | -8/+17 |
* | | mtd: vf610_nfc: mark page as dirty on block erase | Stefan Agner | 2015-03-30 | -2/+1 |
* | | nand: yaffs: Remove the "nand write.yaffs" command | Peter Tyser | 2015-03-30 | -65/+12 |
* | | nand: Remove CONFIG_MTD_NAND_VERIFY_WRITE | Peter Tyser | 2015-03-30 | -248/+0 |
* | | nand: Add verification functions | Peter Tyser | 2015-03-30 | -1/+96 |
* | | mtd: nand: mxs: fix PIO_WORDs in mxs_nand_write_buf() | Luca Ellero | 2015-03-30 | -1/+1 |
* | | mtd: nand: mxs: fix PIO_WORDs in mxs_nand_read_buf() | Luca Ellero | 2015-03-30 | -1/+1 |
|/ |
|
* | omap: gpmc: 'nandecc sw' can use HAM1 or BCH8 | Ash Charles | 2015-03-05 | -1/+11 |
* | mtd: nand: omap_gpmc: Make ready/busy pins configurable | Michal Sojka | 2015-03-05 | -2/+14 |
* | kconfig: remove unneeded dependency on !SPL_BUILD | Masahiro Yamada | 2015-02-24 | -4/+0 |
* | kconfig: switch to single .config configuration | Masahiro Yamada | 2015-02-24 | -1/+1 |
* | mtd, omap: fix case NAND_OMAP_GPMC_PREFETCH not defined | Egli, Samuel | 2015-02-16 | -1/+4 |
* | mtd: atmel_nand: according to pmecc version to perform 0xff page correction | Wu, Josh | 2015-02-07 | -0/+29 |
* | dm: tegra: nand: Remove use of fdtdec GPIO support | Simon Glass | 2015-01-29 | -5/+4 |
* | powerpc: ppc4xx: remove PPChameleonEVB, CATcenter boards | Masahiro Yamada | 2015-01-23 | -5/+0 |
* | mtd: OMAP: Enable GPMC prefetch mode | Daniel Mack | 2015-01-13 | -2/+112 |
* | mtd: nand: do not scan BBT after scrub | Masahiro Yamada | 2015-01-09 | -8/+3 |
* | mtd: nand: Mark the BBT as scanned prior to calling scan_bbt again | Masahiro Yamada | 2015-01-09 | -1/+1 |
* | mtd: nand: revive "nand scrub" command | Masahiro Yamada | 2015-01-09 | -1/+1 |
* | mtd: nand: omap_gpmc: fix error handling | Guido MartÃnez | 2015-01-05 | -1/+2 |
* | driver/mtd: Fix IFC compilation warnings | Jaiprakash Singh | 2014-12-11 | -1/+1 |
* | arm: ls102xa: Add NAND boot support for LS1021AQDS board | Alison Wang | 2014-12-11 | -0/+10 |
* | mtd: nand: omap_gpmc: Always use ready/busy pin | Stefan Roese | 2014-12-04 | -5/+4 |
* | mtd: nand: s3c: Unify the register definition and naming | Marek Vasut | 2014-11-26 | -19/+19 |
* | mtd/nand/vf610_nfc: Disable subpage writes | Sanchayan Maity | 2014-11-26 | -0/+3 |
* | mtd: denali: set some registers after nand_scan_ident() | Masahiro Yamada | 2014-11-26 | -0/+11 |
* | mtd: denali: use CONFIG_SYS_NAND_SELF_INIT | Masahiro Yamada | 2014-11-26 | -40/+93 |
* | nand: reinstate lazy bad block scanning | Rostislav Lisovy | 2014-11-26 | -3/+7 |
* | linux/kernel.h: sync min, max, min3, max3 macros with Linux | Masahiro Yamada | 2014-11-23 | -1/+1 |
* | mtd: atmel_nand: runtime to build gf table for pmecc | Josh Wu | 2014-11-17 | -1/+78 |
* | spl, mtd, nand, atmel_nand: invert device ready pin logic | Heiko Schocher | 2014-11-17 | -3/+3 |
* | spl, nand, atmel_nand: add erase one block function | Heiko Schocher | 2014-11-17 | -0/+33 |
* | mtd: atmel_nand: add missing include | Heiko Schocher | 2014-11-17 | -0/+1 |
* | Merge branch 'master' of git://www.denx.de/git/u-boot-imx | Tom Rini | 2014-11-05 | -2/+7 |
|\ |
|
| * | mtd: nand: mxs: Add ECC geometry for 2048b/112b NAND | Marek Vasut | 2014-10-30 | -2/+7 |
* | | omap_gpmc: fix warnigs with W=1 | Jeroen Hofstee | 2014-10-25 | -18/+18 |
* | | arm: marvell: Move arch/kirkwood.h to arch/soc.h | Stefan Roese | 2014-10-23 | -1/+1 |
|/ |
|
* | Merge branch 'u-boot/master' into 'u-boot-arm/master' | Albert ARIBAUD | 2014-10-11 | -2/+10 |
|\ |
|
| * | mtd: denali: support NAND_CMD_RNDOUT command | Masahiro Yamada | 2014-10-09 | -0/+7 |
| * | mtd: denali: fix NAND_CMD_PARAM command | Masahiro Yamada | 2014-10-09 | -2/+3 |
* | | Merge remote-tracking branch 'u-boot-imx/master' | Albert ARIBAUD | 2014-10-08 | -0/+725 |
|\ \
| |/
|/| |
|