diff options
Diffstat (limited to 'include/configs')
| -rw-r--r-- | include/configs/P1010RDB.h | 101 |
1 files changed, 87 insertions, 14 deletions
diff --git a/include/configs/P1010RDB.h b/include/configs/P1010RDB.h index 032c078..c6b9aca 100644 --- a/include/configs/P1010RDB.h +++ b/include/configs/P1010RDB.h @@ -120,7 +120,11 @@ #endif /* controller 2, Slot 2, tgtid 2, Base address 9000 */ +#if defined(CONFIG_P1010RDB_PA) #define CONFIG_SYS_PCIE2_NAME "PCIe Slot" +#elif defined(CONFIG_P1010RDB_PB) +#define CONFIG_SYS_PCIE2_NAME "mini PCIe Slot" +#endif #define CONFIG_SYS_PCIE2_MEM_VIRT 0xa0000000 #ifdef CONFIG_PHYS_64BIT #define CONFIG_SYS_PCIE2_MEM_BUS 0xc0000000 @@ -200,25 +204,24 @@ extern unsigned long get_sdram_size(void); #define CONFIG_SYS_DDR_INIT_ADDR 0x00000000 #define CONFIG_SYS_DDR_INIT_EXT_ADDR 0x00000000 #define CONFIG_SYS_DDR_MODE_CONTROL 0x00000000 - #define CONFIG_SYS_DDR_ZQ_CONTROL 0x89080600 #define CONFIG_SYS_DDR_SR_CNTR 0x00000000 #define CONFIG_SYS_DDR_RCW_1 0x00000000 #define CONFIG_SYS_DDR_RCW_2 0x00000000 -#define CONFIG_SYS_DDR_CONTROL 0x470C0000 /* Type = DDR3 */ -#define CONFIG_SYS_DDR_CONTROL_2 0x04401010 +#define CONFIG_SYS_DDR_CONTROL 0xc70c0008 /* Type = DDR3 */ +#define CONFIG_SYS_DDR_CONTROL_2 0x24401000 #define CONFIG_SYS_DDR_TIMING_4 0x00000001 #define CONFIG_SYS_DDR_TIMING_5 0x03402400 -#define CONFIG_SYS_DDR_TIMING_3_800 0x00020000 -#define CONFIG_SYS_DDR_TIMING_0_800 0x00330004 -#define CONFIG_SYS_DDR_TIMING_1_800 0x6f6B4644 +#define CONFIG_SYS_DDR_TIMING_3_800 0x00030000 +#define CONFIG_SYS_DDR_TIMING_0_800 0x00110104 +#define CONFIG_SYS_DDR_TIMING_1_800 0x6f6b8644 #define CONFIG_SYS_DDR_TIMING_2_800 0x0FA888CF #define CONFIG_SYS_DDR_CLK_CTRL_800 0x03000000 -#define CONFIG_SYS_DDR_MODE_1_800 0x40461520 -#define CONFIG_SYS_DDR_MODE_2_800 0x8000c000 +#define CONFIG_SYS_DDR_MODE_1_800 0x00441420 +#define CONFIG_SYS_DDR_MODE_2_800 0x00000000 #define CONFIG_SYS_DDR_INTERVAL_800 0x0C300100 -#define CONFIG_SYS_DDR_WRLVL_CONTROL_800 0x8655A608 +#define CONFIG_SYS_DDR_WRLVL_CONTROL_800 0x8675f608 /* settings for DDR3 at 667MT/s */ #define CONFIG_SYS_DDR_TIMING_3_667 0x00010000 @@ -315,6 +318,8 @@ extern unsigned long get_sdram_size(void); | CSPR_MSEL_NAND \ | CSPR_V) #define CONFIG_SYS_NAND_AMASK IFC_AMASK(64*1024) + +#if defined(CONFIG_P1010RDB_PA) #define CONFIG_SYS_NAND_CSOR (CSOR_NAND_ECC_ENC_EN /* ECC on encode */ \ | CSOR_NAND_ECC_DEC_EN /* ECC on decode */ \ | CSOR_NAND_ECC_MODE_4 /* 4-bit ECC */ \ @@ -322,13 +327,26 @@ extern unsigned long get_sdram_size(void); | CSOR_NAND_PGS_512 /* Page Size = 512b */ \ | CSOR_NAND_SPRZ_16 /* Spare size = 16 */ \ | CSOR_NAND_PB(32)) /* 32 Pages Per Block */ +#define CONFIG_SYS_NAND_BLOCK_SIZE (16 * 1024) + +#elif defined(CONFIG_P1010RDB_PB) +#define CONFIG_SYS_NAND_ONFI_DETECTION +#define CONFIG_SYS_NAND_CSOR (CSOR_NAND_ECC_ENC_EN /* ECC on encode */ \ + | CSOR_NAND_ECC_DEC_EN /* ECC on decode */ \ + | CSOR_NAND_ECC_MODE_4 /* 4-bit ECC */ \ + | CSOR_NAND_RAL_3 /* RAL = 3Byes */ \ + | CSOR_NAND_PGS_4K /* Page Size = 4K */ \ + | CSOR_NAND_SPRZ_224 /* Spare size = 224 */ \ + | CSOR_NAND_PB(128)) /*Pages Per Block = 128 */ +#define CONFIG_SYS_NAND_BLOCK_SIZE (512 * 1024) +#endif #define CONFIG_SYS_NAND_BASE_LIST { CONFIG_SYS_NAND_BASE } #define CONFIG_SYS_MAX_NAND_DEVICE 1 #define CONFIG_MTD_NAND_VERIFY_WRITE #define CONFIG_CMD_NAND -#define CONFIG_SYS_NAND_BLOCK_SIZE (16 * 1024) +#if defined(CONFIG_P1010RDB_PA) /* NAND Flash Timing Params */ #define CONFIG_SYS_NAND_FTIM0 FTIM0_NAND_TCCST(0x01) | \ FTIM0_NAND_TWP(0x0C) | \ @@ -343,6 +361,23 @@ extern unsigned long get_sdram_size(void); FTIM2_NAND_TWHRE(0x0f) #define CONFIG_SYS_NAND_FTIM3 FTIM3_NAND_TWW(0x04) +#elif defined(CONFIG_P1010RDB_PB) +/* support MT29F16G08ABABAWP 4k-pagesize 2G-bytes NAND */ +/* ONFI NAND Flash mode0 Timing Params */ +#define CONFIG_SYS_NAND_FTIM0 (FTIM0_NAND_TCCST(0x07)| \ + FTIM0_NAND_TWP(0x18) | \ + FTIM0_NAND_TWCHT(0x07) | \ + FTIM0_NAND_TWH(0x0a)) +#define CONFIG_SYS_NAND_FTIM1 (FTIM1_NAND_TADLE(0x32)| \ + FTIM1_NAND_TWBE(0x39) | \ + FTIM1_NAND_TRR(0x0e) | \ + FTIM1_NAND_TRP(0x18)) +#define CONFIG_SYS_NAND_FTIM2 (FTIM2_NAND_TRAD(0x0f) | \ + FTIM2_NAND_TREH(0x0a) | \ + FTIM2_NAND_TWHRE(0x1e)) +#define CONFIG_SYS_NAND_FTIM3 0x0 +#endif + #define CONFIG_SYS_NAND_DDR_LAW 11 /* Set up IFC registers for boot location NOR/NAND */ @@ -475,10 +510,20 @@ extern unsigned long get_sdram_size(void); #define CONFIG_SYS_FSL_I2C2_SLAVE 0x7F #define CONFIG_SYS_FSL_I2C2_OFFSET 0x3100 #define I2C_PCA9557_ADDR1 0x18 +#define I2C_PCA9557_ADDR2 0x19 #define I2C_PCA9557_BUS_NUM 0 /* I2C EEPROM */ -#undef CONFIG_ID_EEPROM +#if defined(CONFIG_P1010RDB_PB) +#define CONFIG_ID_EEPROM +#ifdef CONFIG_ID_EEPROM +#define CONFIG_SYS_I2C_EEPROM_NXID +#endif +#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 +#define CONFIG_SYS_I2C_EEPROM_ADDR 0x57 +#define CONFIG_SYS_EEPROM_BUS_NUM 0 +#define MAX_NUM_PORTS 9 /* for 128Bytes EEPROM */ +#endif /* enable read and write access to EEPROM */ #define CONFIG_CMD_EEPROM #define CONFIG_SYS_I2C_MULTI_EEPROMS @@ -602,9 +647,14 @@ extern unsigned long get_sdram_size(void); #define CONFIG_ENV_SIZE 0x2000 #elif defined(CONFIG_NAND) #define CONFIG_ENV_IS_IN_NAND +#if defined(CONFIG_P1010RDB_PA) #define CONFIG_ENV_SIZE CONFIG_SYS_NAND_BLOCK_SIZE +#define CONFIG_ENV_RANGE (3 * CONFIG_ENV_SIZE) /* 3*16=48K for env */ +#elif defined(CONFIG_P1010RDB_PB) +#define CONFIG_ENV_SIZE (16 * 1024) +#define CONFIG_ENV_RANGE (32 * CONFIG_ENV_SIZE) /* new block size 512K */ +#endif #define CONFIG_ENV_OFFSET ((512 * 1024) + CONFIG_SYS_NAND_BLOCK_SIZE) -#define CONFIG_ENV_RANGE (3 * CONFIG_ENV_SIZE) #elif defined(CONFIG_SYS_RAMBOOT) #define CONFIG_ENV_IS_NOWHERE /* Store ENV in memory only */ #define CONFIG_ENV_ADDR (CONFIG_SYS_MONITOR_BASE - 0x1000) @@ -697,7 +747,6 @@ extern unsigned long get_sdram_size(void); #define CONFIG_HAS_ETH2 #endif -#define CONFIG_HOSTNAME P1010RDB #define CONFIG_ROOTPATH "/opt/nfsroot" #define CONFIG_BOOTFILE "uImage" #define CONFIG_UBOOTPATH u-boot.bin/* U-Boot image on TFTP server */ @@ -736,7 +785,31 @@ extern unsigned long get_sdram_size(void); "ext2load usb 0:4 $loadaddr $bootfile;" \ "ext2load usb 0:4 $fdtaddr $fdtfile;" \ "ext2load usb 0:4 $ramdiskaddr $ramdiskfile;" \ - "bootm $loadaddr $ramdiskaddr $fdtaddr\0" \ + "bootm $loadaddr $ramdiskaddr $fdtaddr\0" \ + CONFIG_BOOTMODE + +#if defined(CONFIG_P1010RDB_PA) +#define CONFIG_BOOTMODE \ + "boot_bank0=i2c dev 0; i2c mw 18 1 f1; i2c mw 18 3 f0;" \ + "mw.b ffb00011 0; mw.b ffb00009 0; reset\0" \ + "boot_bank1=i2c dev 0; i2c mw 18 1 f1; i2c mw 18 3 f0;" \ + "mw.b ffb00011 0; mw.b ffb00009 1; reset\0" \ + "boot_nand=i2c dev 0; i2c mw 18 1 f9; i2c mw 18 3 f0;" \ + "mw.b ffb00011 0; mw.b ffb00017 1; reset\0" + +#elif defined(CONFIG_P1010RDB_PB) +#define CONFIG_BOOTMODE \ + "boot_bank0=i2c dev 0; i2c mw 18 1 fe; i2c mw 18 3 0;" \ + "i2c mw 19 1 2; i2c mw 19 3 e1; reset\0" \ + "boot_bank1=i2c dev 0; i2c mw 18 1 fe; i2c mw 18 3 0;" \ + "i2c mw 19 1 12; i2c mw 19 3 e1; reset\0" \ + "boot_nand=i2c dev 0; i2c mw 18 1 fc; i2c mw 18 3 0;" \ + "i2c mw 19 1 8; i2c mw 19 3 f7; reset\0" \ + "boot_spi=i2c dev 0; i2c mw 18 1 fa; i2c mw 18 3 0;" \ + "i2c mw 19 1 0; i2c mw 19 3 f7; reset\0" \ + "boot_sd=i2c dev 0; i2c mw 18 1 f8; i2c mw 18 3 0;" \ + "i2c mw 19 1 4; i2c mw 19 3 f3; reset\0" +#endif #define CONFIG_RAMBOOTCOMMAND \ "setenv bootargs root=/dev/ram rw " \ |