diff options
-rw-r--r-- | CHANGELOG | 15 | ||||
-rw-r--r-- | cpu/i386/sc520.c | 18 | ||||
-rw-r--r-- | cpu/i386/sc520_asm.S | 54 | ||||
-rw-r--r-- | drivers/dm9000x.c | 3 | ||||
-rw-r--r-- | include/common.h | 2 | ||||
-rw-r--r-- | include/fat.h | 8 | ||||
-rw-r--r-- | net/tftp.c | 2 |
7 files changed, 91 insertions, 11 deletions
@@ -2,6 +2,21 @@ Changes since U-Boot 1.1.4: ====================================================================== +* Update for SC520 board. + Patch by David Updegraff, 02 Dec 2005 + +* Fixed common.h spelling error. + Patch by Cory Tusar, 30 Nov 2005 + +* Fix typo. + Patch by Andreas Engel, 28 Nov 2005 + +* Fix fatload command on FAT32 formatted partitions. + Patch by Joachim Jaeger, 18 Nov 2005 + +* Fix drivers/dm9000.c when configured in 32 bit mode. + Patch by Eric Benard, 17 Nov 2005 + * Cleanup debug code for yucca board. * MCC200: restrict addressable flash space to 32 MB diff --git a/cpu/i386/sc520.c b/cpu/i386/sc520.c index c83f0bb..1c4370b 100644 --- a/cpu/i386/sc520.c +++ b/cpu/i386/sc520.c @@ -31,7 +31,9 @@ #include <common.h> #include <config.h> #include <pci.h> +#ifdef CONFIG_SC520_SSI #include <ssi.h> +#endif #include <asm/io.h> #include <asm/pci.h> #include <asm/ic/sc520.h> @@ -143,7 +145,15 @@ unsigned long init_sc520_dram(void) u32 dram_present=0; u32 dram_ctrl; - +#ifdef CFG_SDRAM_DRCTMCTL + /* these memory control registers are set up in the assember part, + * in sc520_asm.S, during 'mem_init'. If we muck with them here, + * after we are running a stack in RAM, we have troubles. Besides, + * these refresh and delay values are better ? simply specified + * outright in the include/configs/{cfg} file since the HW designer + * simply dictates it. + */ +#else int val; int cas_precharge_delay = CFG_SDRAM_PRECHARGE_DELAY; @@ -162,6 +172,7 @@ unsigned long init_sc520_dram(void) } else { val = 3; /* 62.4us */ } + write_mmcr_byte(SC520_DRCCTL, (read_mmcr_byte(SC520_DRCCTL) & 0xcf) | (val<<4)); val = read_mmcr_byte(SC520_DRCTMCTL); @@ -181,13 +192,12 @@ unsigned long init_sc520_dram(void) val |= 1; } write_mmcr_byte(SC520_DRCTMCTL, val); - +#endif /* We read-back the configuration of the dram * controller that the assembly code wrote */ dram_ctrl = read_mmcr_long(SC520_DRCBENDADR); - bd->bi_dram[0].start = 0; if (dram_ctrl & 0x80) { /* bank 0 enabled */ @@ -274,7 +284,7 @@ int pci_sc520_set_irq(int pci_pin, int irq) { int i; -# if 0 +# if 1 printf("set_irq(): map INT%c to IRQ%d\n", pci_pin + 'A', irq); #endif if (irq < 0 || irq > 15) { diff --git a/cpu/i386/sc520_asm.S b/cpu/i386/sc520_asm.S index 80464fa..e1fa37a 100644 --- a/cpu/i386/sc520_asm.S +++ b/cpu/i386/sc520_asm.S @@ -113,6 +113,7 @@ .equ DRCCFG, 0x0fffef014 /* DRAM bank configuration register */ .equ DRCBENDADR, 0x0fffef018 /* DRAM bank ending address register */ .equ ECCCTL, 0x0fffef020 /* DRAM ECC control register */ +.equ ECCINT, 0x0fffefd18 /* DRAM ECC nmi-INT mapping */ .equ DBCTL, 0x0fffef040 /* DRAM buffer control register */ .equ CACHELINESZ, 0x00000010 /* size of our cache line (read buffer) */ @@ -459,6 +460,12 @@ emptybank: incl %edi loop cleanuplp +#if defined CFG_SDRAM_DRCTMCTL + /* just have your hardware desinger _GIVE_ you what you need here! */ + movl $DRCTMCTL, %edi + movb $CFG_SDRAM_DRCTMCTL,%al + movb (%edi), %al +#else #if defined(CFG_SDRAM_CAS_LATENCY_2T) || defined(CFG_SDRAM_CAS_LATENCY_3T) /* set the CAS latency now since it is hard to do * when we run from the RAM */ @@ -470,7 +477,8 @@ emptybank: #ifdef CFG_SDRAM_CAS_LATENCY_3T orb $0x10, %al #endif - movb %al, (%edi) + movb %al, (%edi) +#endif #endif movl $DRCCTL, %edi /* DRAM Control register */ movb $0x3,%al /* Load mode register cmd */ @@ -528,9 +536,49 @@ bank0: movl (%edi), %eax shll $22, %eax movl %eax, %ebx -done: movl %ebx, %eax +done: + movl %ebx, %eax + +#if CFG_SDRAM_ECC_ENABLE + /* A nominal memory test: just a byte at each address line */ + movl %eax, %ecx + shrl $0x1, %ecx + movl $0x1, %edi +memtest0: + movb $0xa5, (%edi) + cmpb $0xa5, (%edi) + jne out + shrl $1, %ecx + andl %ecx,%ecx + jz set_ecc + shll $1, %edi + jmp memtest0 + +set_ecc: + /* clear all ram with a memset */ + movl %eax, %ecx + xorl %esi, %esi + xorl %edi, %edi + xorl %eax, %eax + shrl $2, %ecx + cld + rep stosl + /* enable read, write buffers */ + movb $0x11, %al + movl $DBCTL, %edi + movb %al, (%edi) + /* enable NMI mapping for ECC */ + movl $ECCINT, %edi + mov $0x10, %al + movb %al, (%edi) + /* Turn on ECC */ + movl $ECCCTL, %edi + mov $0x05, %al + movb %al, (%edi) +#endif +out: + movl %ebx, %eax jmp *%ebp - #endif /* CONFIG_SC520 */ diff --git a/drivers/dm9000x.c b/drivers/dm9000x.c index 0e475d4..6877076 100644 --- a/drivers/dm9000x.c +++ b/drivers/dm9000x.c @@ -436,6 +436,9 @@ eth_rx(void) u8 rxbyte, *rdptr = (u8 *) NetRxPackets[0]; u16 RxStatus, RxLen = 0; u32 tmplen, i; +#ifdef CONFIG_DM9000_USE_32BIT + u32 tmpdata; +#endif /* Check packet ready or not */ DM9000_ior(DM9000_MRCMDX); /* Dummy read */ diff --git a/include/common.h b/include/common.h index bd41ae1..9a19001 100644 --- a/include/common.h +++ b/include/common.h @@ -603,7 +603,7 @@ void show_boot_progress (int status); #endif #ifdef CONFIG_INIT_CRITICAL -#error CONFIG_INIT_CRITICAL is depracted! +#error CONFIG_INIT_CRITICAL is deprecated! #error Read section CONFIG_SKIP_LOWLEVEL_INIT in README. #endif diff --git a/include/fat.h b/include/fat.h index 0645458..92638d5 100644 --- a/include/fat.h +++ b/include/fat.h @@ -175,15 +175,19 @@ typedef struct dir_slot { __u8 name11_12[4]; /* Last 2 characters in name */ } dir_slot; -/* Private filesystem parameters */ +/* Private filesystem parameters + * + * Note: FAT buffer has to be 32 bit aligned + * (see FAT32 accesses) + */ typedef struct { + __u8 fatbuf[FATBUFSIZE]; /* Current FAT buffer */ int fatsize; /* Size of FAT in bits */ __u16 fatlength; /* Length of FAT in sectors */ __u16 fat_sect; /* Starting sector of the FAT */ __u16 rootdir_sect; /* Start sector of root directory */ __u16 clust_size; /* Size of clusters in sectors */ short data_begin; /* The sector of the first cluster, can be negative */ - __u8 fatbuf[FATBUFSIZE]; /* Current FAT buffer */ int fatbufnum; /* Used by get_fatent, init to -1 */ } fsdata; @@ -225,7 +225,7 @@ TftpHandler (uchar * pkt, unsigned dest, unsigned src, unsigned len) if (TftpBlock == 0) { TftpBlockWrap++; TftpBlockWrapOffset += TFTP_BLOCK_SIZE * TFTP_SEQUENCE_SIZE; - printf ("\n\t %lu MB reveived\n\t ", TftpBlockWrapOffset>>20); + printf ("\n\t %lu MB received\n\t ", TftpBlockWrapOffset>>20); } else { if (((TftpBlock - 1) % 10) == 0) { putc ('#'); |