From b87996d24a41cfc15fea125e5c805163af4acba1 Mon Sep 17 00:00:00 2001 From: Cyril Chemparathy Date: Mon, 7 Jun 2010 14:13:27 -0400 Subject: ARM1176: Coexist with other ARM1176 platforms The current ARM1176 CPU specific code is too specific to the SMDK6400 architecture. The following changes were necessary prerequisites for the addition of other SoCs based on ARM1176. Existing board's (SMDK6400) configuration has been modified to keep behavior unchanged despite these changes. 1. Peripheral port remap configurability The earlier code had hardcoded remap values specific to s3c64xx in start.S. This change makes the peripheral port remap addresses and sizes configurable. 2. U-Boot code relocation support Most architectures allow u-boot code to run initially at a different address (possibly in NOR) and then get relocated to its final resting place in RAM. Added support for this capability in ARM1176 architecture. 3. Disable TCM if necessary If a ROM based bootloader happened to have initialized TCM, we disable it here to keep things sane. 4. Remove unnecessary SoC specific includes ARM1176 code does not really need this SoC specific include. The presence of this include prevents builds on other ARM1176 archs. 5. Modified virt-to-phys conversion during MMU disable The original MMU disable code masks out too many bits from the load address when it tries to figure out the physical address of the jump target label. Consequently, it ends up branching to the wrong address after disabling the MMU. Signed-off-by: Cyril Chemparathy Signed-off-by: Sandeep Paulraj --- include/configs/smdk6400.h | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-) (limited to 'include') diff --git a/include/configs/smdk6400.h b/include/configs/smdk6400.h index f04feae..624fe04 100644 --- a/include/configs/smdk6400.h +++ b/include/configs/smdk6400.h @@ -40,6 +40,12 @@ #define CONFIG_S3C64XX 1 /* in a SAMSUNG S3C64XX Family */ #define CONFIG_SMDK6400 1 /* on a SAMSUNG SMDK6400 Board */ +#define CONFIG_SKIP_RELOCATE_UBOOT + +#define CONFIG_PERIPORT_REMAP +#define CONFIG_PERIPORT_BASE 0x70000000 +#define CONFIG_PERIPORT_SIZE 0x13 + #define CONFIG_SYS_SDRAM_BASE 0x50000000 /* input clock of PLL: SMDK6400 has 12MHz input clock */ @@ -61,8 +67,6 @@ #define CONFIG_DISPLAY_CPUINFO #define CONFIG_DISPLAY_BOARDINFO -#undef CONFIG_SKIP_RELOCATE_UBOOT - /* * Size of malloc() pool */ -- cgit v1.1