From 1167a2fd56138b716e01370c4267f3b70bf9ffa0 Mon Sep 17 00:00:00 2001 From: Kumar Gala Date: Tue, 26 Aug 2008 08:02:30 -0500 Subject: FSL DDR: Convert MPC8544DS to new DDR code. Signed-off-by: Kumar Gala --- include/configs/MPC8544DS.h | 38 ++++++++++++++++++++------------------ 1 file changed, 20 insertions(+), 18 deletions(-) (limited to 'include') diff --git a/include/configs/MPC8544DS.h b/include/configs/MPC8544DS.h index 9a77b7b..5738192 100644 --- a/include/configs/MPC8544DS.h +++ b/include/configs/MPC8544DS.h @@ -46,15 +46,6 @@ #define CONFIG_TSEC_ENET /* tsec ethernet support */ #define CONFIG_ENV_OVERWRITE -#define CONFIG_SPD_EEPROM /* Use SPD EEPROM for DDR setup */ -#undef CONFIG_DDR_DLL -#define CONFIG_DDR_2T_TIMING /* Sets the 2T timing bit */ - -#define CONFIG_DDR_ECC /* only for ECC DDR module */ -#define CONFIG_ECC_INIT_VIA_DDRCONTROLLER /* DDR controller or DMA? */ -#define CONFIG_MEM_INIT_VALUE 0xDeadBeef - -#define CONFIG_DDR_ECC_CMD #define CONFIG_INTERRUPTS /* enable pci, srio, ddr interrupts */ /* @@ -64,8 +55,6 @@ */ #define CONFIG_ASSUME_AMD_FLASH -#define MPC85xx_DDR_SDRAM_CLK_CNTL /* 85xx has clock control reg */ - #ifndef __ASSEMBLY__ extern unsigned long get_board_sys_clk(unsigned long dummy); #endif @@ -101,17 +90,27 @@ extern unsigned long get_board_sys_clk(unsigned long dummy); #define CFG_PCIE2_ADDR (CFG_CCSRBAR+0x9000) #define CFG_PCIE3_ADDR (CFG_CCSRBAR+0xb000) -/* - * DDR Setup - */ -#define CFG_DDR_SDRAM_BASE 0x00000000 /* DDR is system memory*/ +/* DDR Setup */ +#define CONFIG_FSL_DDR2 +#undef CONFIG_FSL_DDR_INTERACTIVE +#define CONFIG_SPD_EEPROM /* Use SPD EEPROM for DDR setup */ +#define CONFIG_DDR_SPD + +#undef CONFIG_ECC_INIT_VIA_DDRCONTROLLER /* DDR controller or DMA? */ +#define CONFIG_MEM_INIT_VALUE 0xDeadBeef + +#define CFG_DDR_SDRAM_BASE 0x00000000 #define CFG_SDRAM_BASE CFG_DDR_SDRAM_BASE +#define CONFIG_VERY_BIG_RAM + +#define CONFIG_NUM_DDR_CONTROLLERS 1 +#define CONFIG_DIMM_SLOTS_PER_CTLR 1 +#define CONFIG_CHIP_SELECTS_PER_CTRL 2 +/* I2C addresses of SPD EEPROMs */ #define SPD_EEPROM_ADDRESS 0x51 /* DDR DIMM */ -/* - * Make sure required options are set - */ +/* Make sure required options are set */ #ifndef CONFIG_SPD_EEPROM #error ("CONFIG_SPD_EEPROM is required") #endif @@ -242,6 +241,9 @@ extern unsigned long get_board_sys_clk(unsigned long dummy); #define CONFIG_OF_BOARD_SETUP 1 #define CONFIG_OF_STDOUT_VIA_ALIAS 1 +#define CFG_64BIT_STRTOUL 1 +#define CFG_64BIT_VSPRINTF 1 + /* I2C */ #define CONFIG_FSL_I2C /* Use FSL common I2C driver */ #define CONFIG_HARD_I2C /* I2C with hardware support */ -- cgit v1.1