From 0b38fffbe413fc0725c750d046ca62c23fca196e Mon Sep 17 00:00:00 2001 From: Wolfram Sang Date: Wed, 5 Dec 2012 10:48:47 +0000 Subject: mtd: nand: mxs: reset BCH earlier, too, to avoid NAND startup problems It could happen (1 out of 100 times) that NAND did not start up correctly after warm rebooting, so we end up with various failures or DMA timed out due to a stalled BCH. When resetting BCH together with GPMI, the issue could not be observed anymore (after 10000+ reboots). We probably need the consistent state already before sending commands to NAND. This behaviour was observed in barebox and kernel, so I assume it affects U-Boot as well. I chose to keep the extra reset for BCH when changing the flash layout to be on the safe side. Signed-off-by: Wolfram Sang Acked-by: Marek Vasut --- drivers/mtd/nand/mxs_nand.c | 3 +++ 1 file changed, 3 insertions(+) (limited to 'drivers') diff --git a/drivers/mtd/nand/mxs_nand.c b/drivers/mtd/nand/mxs_nand.c index 4701be8..e38e151 100644 --- a/drivers/mtd/nand/mxs_nand.c +++ b/drivers/mtd/nand/mxs_nand.c @@ -1058,6 +1058,8 @@ int mxs_nand_init(struct mxs_nand_info *info) { struct mxs_gpmi_regs *gpmi_regs = (struct mxs_gpmi_regs *)MXS_GPMI_BASE; + struct mxs_bch_regs *bch_regs = + (struct mxs_bch_regs *)MXS_BCH_BASE; int i = 0, j; info->desc = malloc(sizeof(struct mxs_dma_desc *) * @@ -1081,6 +1083,7 @@ int mxs_nand_init(struct mxs_nand_info *info) /* Reset the GPMI block. */ mxs_reset_block(&gpmi_regs->hw_gpmi_ctrl0_reg); + mxs_reset_block(&bch_regs->hw_bch_ctrl_reg); /* * Choose NAND mode, set IRQ polarity, disable write protection and -- cgit v1.1