From 9a88180bfbb6ee7b2fba5516391ff0e611794de5 Mon Sep 17 00:00:00 2001 From: Stefan Agner Date: Wed, 13 Jul 2016 00:25:37 -0700 Subject: usb: ehci-mx6: configure power polarity in usb_power_config USBNC_n_CTRL1 bit 9 actually controls the power pin polarity. Rename UCTRL_PM to align reference manual and set the bit in the appropriate callback usb_power_config. Signed-off-by: Stefan Agner --- drivers/usb/host/ehci-mx6.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) (limited to 'drivers') diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c index 069f116..277f461 100644 --- a/drivers/usb/host/ehci-mx6.c +++ b/drivers/usb/host/ehci-mx6.c @@ -49,7 +49,7 @@ #define USBNC_OFFSET 0x200 #define USBNC_PHYSTATUS_ID_DIG (1 << 4) /* otg_id status */ #define USBNC_PHYCFG2_ACAENB (1 << 4) /* otg_id detection enable */ -#define UCTRL_PM (1 << 9) /* OTG Power Mask */ +#define UCTRL_PWR_POL (1 << 9) /* OTG Polarity of Power Pin */ #define UCTRL_OVER_CUR_POL (1 << 8) /* OTG Polarity of Overcurrent */ #define UCTRL_OVER_CUR_DIS (1 << 7) /* Disable OTG Overcurrent Detection */ @@ -207,12 +207,16 @@ static void usb_power_config(int index) struct usbnc_regs *usbnc = (struct usbnc_regs *)(USB_BASE_ADDR + (0x10000 * index) + USBNC_OFFSET); void __iomem *phy_cfg2 = (void __iomem *)(&usbnc->phy_cfg2); + void __iomem *ctrl = (void __iomem *)(&usbnc->ctrl1); /* * Clear the ACAENB to enable usb_otg_id detection, * otherwise it is the ACA detection enabled. */ clrbits_le32(phy_cfg2, USBNC_PHYCFG2_ACAENB); + + /* Set power polarity to high active */ + setbits_le32(ctrl, UCTRL_PWR_POL); } int usb_phy_mode(int port) @@ -250,11 +254,7 @@ static void usb_oc_config(int index) setbits_le32(ctrl, UCTRL_OVER_CUR_POL); #endif -#if defined(CONFIG_MX6) setbits_le32(ctrl, UCTRL_OVER_CUR_DIS); -#elif defined(CONFIG_MX7) - setbits_le32(ctrl, UCTRL_OVER_CUR_DIS | UCTRL_PM); -#endif } /** -- cgit v1.1