From a6f70a3d1456e6ce97e0f00ac2d5ff8ae22027d6 Mon Sep 17 00:00:00 2001 From: Vagrant Cascadian Date: Tue, 15 Mar 2016 12:16:39 -0700 Subject: Fix spelling of "transferred". Signed-off-by: Vagrant Cascadian Acked-by: Marek Vasut Reviewed-by: Simon Glass Reviewed-by: Tom Rini --- doc/README.POST | 2 +- doc/device-tree-bindings/spi/spi-bus.txt | 2 +- doc/kwboot.1 | 2 +- 3 files changed, 3 insertions(+), 3 deletions(-) (limited to 'doc') diff --git a/doc/README.POST b/doc/README.POST index 6815d49..a9335f4 100644 --- a/doc/README.POST +++ b/doc/README.POST @@ -494,7 +494,7 @@ This test will verify the following ALU instructions: This group will contain: b, bl, bc. The first 2 instructions (b, bl) will be verified by jumping to - a fixed address and checking whether control was transfered to + a fixed address and checking whether control was transferred to that very point. For the bl instruction the value of the link register will be checked as well (using mfspr). To verify the bc instruction various combinations of the BI/BO fields, the CTR diff --git a/doc/device-tree-bindings/spi/spi-bus.txt b/doc/device-tree-bindings/spi/spi-bus.txt index 5c8720a..420ec95 100644 --- a/doc/device-tree-bindings/spi/spi-bus.txt +++ b/doc/device-tree-bindings/spi/spi-bus.txt @@ -63,7 +63,7 @@ contain the following properties. a header byte before reading data from the slave. Some SPI controllers and devices support Dual and Quad SPI transfer mode. -It allows data in SPI system transfered in 2 wires(DUAL) or 4 wires(QUAD). +It allows data in SPI system transferred in 2 wires(DUAL) or 4 wires(QUAD). Now the value that spi-tx-bus-width and spi-rx-bus-width can receive is only 1(SINGLE), 2(DUAL) and 4(QUAD). Dual/Quad mode is not allowed when 3-wire mode is used. diff --git a/doc/kwboot.1 b/doc/kwboot.1 index 25fe69a..1e9ca26 100644 --- a/doc/kwboot.1 +++ b/doc/kwboot.1 @@ -20,7 +20,7 @@ must conform to Marvell's BootROM firmware image format Following power-up or a system reset, system BootROM code polls the UART for a brief period of time, sensing a handshake message which initiates an image upload. This program sends this boot message until -it receives a positive acknowledgement. The image is transfered using +it receives a positive acknowledgement. The image is transferred using Xmodem. Additionally, this program implements a minimal terminal mode, which -- cgit v1.1