From 7124015adad59dea5e72103f63531f3367c6df80 Mon Sep 17 00:00:00 2001 From: Ben Gardiner Date: Thu, 28 Apr 2011 11:03:21 +0000 Subject: README.arm-relocation: get relocated address in gdb When your emulator is connected at reset (or is used to load u-boot) it is possible to get the relocation address from the gd->relocaddr since gd is always in r8 (on ARM) it is addressable before the gdb has remapped symbols. Document this alternate method in-line with the original method written by Heiko Schocher. Signed-off-by: Ben Gardiner CC: Heiko Schocher CC: Wolfgang Denk Acked-by: Heiko Schocher --- doc/README.arm-relocation | 8 ++++++++ 1 file changed, 8 insertions(+) (limited to 'doc/README.arm-relocation') diff --git a/doc/README.arm-relocation b/doc/README.arm-relocation index 8bfb500..45f5ea7 100644 --- a/doc/README.arm-relocation +++ b/doc/README.arm-relocation @@ -164,6 +164,7 @@ Program received signal SIGSTOP, Stopped (signal). add-symbol-file u-boot 0x8ff08000 ^^^^^^^^^^ get this address from u-boot bdinfo command + or get it from gd->relocaddr in gdb => bdinfo rch_number = XXXXXXXXXX @@ -182,4 +183,11 @@ irq_sp = XXXXXXXXXX sp start = XXXXXXXXXX FB base = XXXXXXXXXX +or interrupt execution by any means and re-load the symbols at the location +specified by gd->relocaddr -- this is only valid after board_init_f. + +(gdb) set $s = gd->relocaddr +(gdb) symbol-file +(gdb) add-symbol-file u-boot $s + Now you can use gdb as usual :-) -- cgit v1.1