From 1ecab0f30f9051821fdb5ec1c689b7c531b4feda Mon Sep 17 00:00:00 2001 From: Piotr Wilczek Date: Fri, 7 Mar 2014 14:59:49 +0100 Subject: board:trats2: Enable device tree on Trats2 This patch enables to run Trats2 board on device tree. Signed-off-by: Piotr Wilczek Signed-off-by: Kyungmin Park Signed-off-by: Minkyu Kang --- board/samsung/trats2/trats2.c | 233 ++---------------------------------------- 1 file changed, 10 insertions(+), 223 deletions(-) (limited to 'board') diff --git a/board/samsung/trats2/trats2.c b/board/samsung/trats2/trats2.c index c17c24d..2a6c9f9 100644 --- a/board/samsung/trats2/trats2.c +++ b/board/samsung/trats2/trats2.c @@ -8,15 +8,9 @@ #include #include -#include -#include -#include -#include -#include -#include -#include #include #include +#include #include #include #include @@ -28,7 +22,6 @@ #include #include #include -#include DECLARE_GLOBAL_DATA_PTR; @@ -69,16 +62,6 @@ static void check_hw_revision(void) board_rev = modelrev << 8; } -#ifdef CONFIG_DISPLAY_BOARDINFO -int checkboard(void) -{ - puts("Board:\tTRATS2\n"); - printf("HW Revision:\t0x%04x\n", board_rev); - - return 0; -} -#endif - u32 get_board_rev(void) { return board_rev; @@ -156,33 +139,24 @@ int get_soft_i2c_sda_pin(void) } #endif -int board_early_init_f(void) +int exynos_early_init_f(void) { - check_hw_revision(); board_external_gpio_init(); - gd->flags |= GD_FLG_DISABLE_CONSOLE; - return 0; } static int pmic_init_max77686(void); -int board_init(void) +int exynos_init(void) { - struct exynos4_power *pwr = - (struct exynos4_power *)samsung_get_base_power(); - - gd->bd->bi_boot_params = PHYS_SDRAM_1 + 0x100; - - /* workaround: clear INFORM4..5 */ - writel(0, (unsigned int)&pwr->inform4); - writel(0, (unsigned int)&pwr->inform5); + check_hw_revision(); + printf("HW Revision:\t0x%04x\n", board_rev); return 0; } -int power_init_board(void) +int exynos_power_init(void) { int chrg; struct power_battery *pb; @@ -248,90 +222,6 @@ int power_init_board(void) return 0; } -int dram_init(void) -{ - u32 size_mb; - - size_mb = (get_ram_size((long *)PHYS_SDRAM_1, PHYS_SDRAM_1_SIZE) + - get_ram_size((long *)PHYS_SDRAM_2, PHYS_SDRAM_2_SIZE) + - get_ram_size((long *)PHYS_SDRAM_3, PHYS_SDRAM_3_SIZE) + - get_ram_size((long *)PHYS_SDRAM_4, PHYS_SDRAM_4_SIZE)) >> 20; - - gd->ram_size = size_mb << 20; - - return 0; -} - -void dram_init_banksize(void) -{ - gd->bd->bi_dram[0].start = PHYS_SDRAM_1; - gd->bd->bi_dram[0].size = PHYS_SDRAM_1_SIZE; - gd->bd->bi_dram[1].start = PHYS_SDRAM_2; - gd->bd->bi_dram[1].size = PHYS_SDRAM_2_SIZE; - gd->bd->bi_dram[2].start = PHYS_SDRAM_3; - gd->bd->bi_dram[2].size = PHYS_SDRAM_3_SIZE; - gd->bd->bi_dram[3].start = PHYS_SDRAM_4; - gd->bd->bi_dram[3].size = PHYS_SDRAM_4_SIZE; -} - -int board_mmc_init(bd_t *bis) -{ - int err0, err2 = 0; - - gpio2 = (struct exynos4x12_gpio_part2 *)samsung_get_base_gpio_part2(); - - /* eMMC_EN: SD_0_CDn: GPK0[2] Output High */ - s5p_gpio_direction_output(&gpio2->k0, 2, 1); - s5p_gpio_set_pull(&gpio2->k0, 2, GPIO_PULL_NONE); - - /* - * eMMC GPIO: - * SDR 8-bit@48MHz at MMC0 - * GPK0[0] SD_0_CLK(2) - * GPK0[1] SD_0_CMD(2) - * GPK0[2] SD_0_CDn -> Not used - * GPK0[3:6] SD_0_DATA[0:3](2) - * GPK1[3:6] SD_0_DATA[0:3](3) - * - * DDR 4-bit@26MHz at MMC4 - * GPK0[0] SD_4_CLK(3) - * GPK0[1] SD_4_CMD(3) - * GPK0[2] SD_4_CDn -> Not used - * GPK0[3:6] SD_4_DATA[0:3](3) - * GPK1[3:6] SD_4_DATA[4:7](4) - */ - - err0 = exynos_pinmux_config(PERIPH_ID_SDMMC0, PINMUX_FLAG_8BIT_MODE); - - /* - * MMC device init - * mmc0 : eMMC (8-bit buswidth) - * mmc2 : SD card (4-bit buswidth) - */ - if (err0) - debug("SDMMC0 not configured\n"); - else - err0 = s5p_mmc_init(0, 8); - - /* T-flash detect */ - s5p_gpio_cfg_pin(&gpio2->x3, 4, 0xf); - s5p_gpio_set_pull(&gpio2->x3, 4, GPIO_PULL_UP); - - /* - * Check the T-flash detect pin - * GPX3[4] T-flash detect pin - */ - if (!s5p_gpio_get_value(&gpio2->x3, 4)) { - err2 = exynos_pinmux_config(PERIPH_ID_SDMMC2, PINMUX_FLAG_NONE); - if (err2) - debug("SDMMC2 not configured\n"); - else - err2 = s5p_mmc_init(2, 4); - } - - return err0 & err2; -} - #ifdef CONFIG_USB_GADGET static int s5pc210_phy_control(int on) { @@ -479,46 +369,7 @@ static int pmic_init_max77686(void) */ #ifdef CONFIG_LCD -static struct mipi_dsim_config dsim_config = { - .e_interface = DSIM_VIDEO, - .e_virtual_ch = DSIM_VIRTUAL_CH_0, - .e_pixel_format = DSIM_24BPP_888, - .e_burst_mode = DSIM_BURST_SYNC_EVENT, - .e_no_data_lane = DSIM_DATA_LANE_4, - .e_byte_clk = DSIM_PLL_OUT_DIV8, - .hfp = 1, - - .p = 3, - .m = 120, - .s = 1, - - /* D-PHY PLL stable time spec :min = 200usec ~ max 400usec */ - .pll_stable_time = 500, - - /* escape clk : 10MHz */ - .esc_clk = 20 * 1000000, - - /* stop state holding counter after bta change count 0 ~ 0xfff */ - .stop_holding_cnt = 0x7ff, - /* bta timeout 0 ~ 0xff */ - .bta_timeout = 0xff, - /* lp rx timeout 0 ~ 0xffff */ - .rx_timeout = 0xffff, -}; - -static struct exynos_platform_mipi_dsim dsim_platform_data = { - .lcd_panel_info = NULL, - .dsim_config = &dsim_config, -}; - -static struct mipi_dsim_lcd_device mipi_lcd_device = { - .name = "s6e8ax0", - .id = -1, - .bus_id = 0, - .platform_data = (void *)&dsim_platform_data, -}; - -static int mipi_power(void) +int mipi_power(void) { struct pmic *p = pmic_get("MAX77686_PMIC"); @@ -556,77 +407,13 @@ void exynos_reset_lcd(void) s5p_gpio_set_value(&gpio1->f2, 1, 1); } -vidinfo_t panel_info = { - .vl_freq = 60, - .vl_col = 720, - .vl_row = 1280, - .vl_width = 720, - .vl_height = 1280, - .vl_clkp = CONFIG_SYS_HIGH, - .vl_hsp = CONFIG_SYS_LOW, - .vl_vsp = CONFIG_SYS_LOW, - .vl_dp = CONFIG_SYS_LOW, - .vl_bpix = 4, /* Bits per pixel, 2^4 = 16 */ - - /* s6e8ax0 Panel infomation */ - .vl_hspw = 5, - .vl_hbpd = 10, - .vl_hfpd = 10, - - .vl_vspw = 2, - .vl_vbpd = 1, - .vl_vfpd = 13, - .vl_cmd_allow_len = 0xf, - .mipi_enabled = 1, - - .dual_lcd_enabled = 0, - - .init_delay = 0, - .power_on_delay = 25, - .reset_delay = 0, - .interface_mode = FIMD_RGB_INTERFACE, -}; - -void init_panel_info(vidinfo_t *vid) +void exynos_lcd_misc_init(vidinfo_t *vid) { - vid->logo_on = 1; - vid->resolution = HD_RESOLUTION; - vid->rgb_mode = MODE_RGB_P; - - vid->power_on_delay = 30; - - mipi_lcd_device.reverse_panel = 1; - #ifdef CONFIG_TIZEN get_tizen_logo_info(vid); #endif - - strcpy(dsim_platform_data.lcd_panel_name, mipi_lcd_device.name); - dsim_platform_data.mipi_power = mipi_power; - dsim_platform_data.phy_enable = set_mipi_phy_ctrl; - dsim_platform_data.lcd_panel_info = (void *)vid; - exynos_mipi_dsi_register_lcd_device(&mipi_lcd_device); - +#ifdef CONFIG_S6E8AX0 s6e8ax0_init(); - - exynos_set_dsim_platform_data(&dsim_platform_data); -} -#endif /* LCD */ - -#ifdef CONFIG_MISC_INIT_R -int misc_init_r(void) -{ -#ifdef CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG - set_board_info(); -#endif -#ifdef CONFIG_LCD_MENU - keys_init(); - check_boot_mode(); #endif -#ifdef CONFIG_CMD_BMP - if (panel_info.logo_on) - draw_logo(); -#endif - return 0; } -#endif +#endif /* LCD */ -- cgit v1.1