arm-boot/u-boot-imx.git - U-boot NXP imx6

	Commit message (Collapse)	Author	Age	Lines
*	Clean up the TQM8xx_YYMHz configurations; allow to use the same	wdenk	2004-04-24	-34/+4
\| \| \| \| \| \|	binary image for all clock frequencies. Implement run-time optimization of flash access timing based on the actual bus frequency.
*	Fix bootfile default settings for TQM boards	wdenk	2004-01-31	-1/+1
\|
*	Update for TQM board defaults:	wdenk	2003-08-07	-2/+3
\| \| \| \|	disable clocks_in_mhz, enable boot count limit
*	* Add support for NSCU board	wdenk	2003-07-07	-3/+3
\| \| \| \| \| \| \|	* Add support for TQM823M, TQM850M, TQM855M and TQM860M modules * Add support for Am29LV160ML, Am29LV320ML, and Am29LV640ML mirror bit flash on TQM8xxM modules
*	* Get (mostly) rid of CFG_MONITOR_LEN definition; compute real length	wdenk	2003-05-30	-1/+0
\| \| \| \| \| \| \| \|	instead CFG_MONITOR_LEN is now only used to determine _at_compile_ _time_ (!) if the environment is embedded within the U-Boot image, or in a separate flash sector. * Cleanup CFG_DER #defines in config files (wd maintained only)
*	* Patch by Josef Wagner, 12 Mar 2003:	wdenk	2003-03-12	-1/+1
\| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \|	- 16/32 MB and 50/80 MHz support with auto-detection for IP860 - ETH05 and BEDBUG support for CU824 - added support for MicroSys CPC45 - new BOOTROM/FLASH0 and DOC base for PM826 * Patch by Robert Schwebel, 12 Mar 2003: Fix the chpart command on innokom board * Name cleanup: mv include/asm-i386/ppcboot-i386.h include/asm-i386/u-boot-i386.h s/PPCBoot/U-Boot/ in some files s/pImage/uImage/ in some files * Patch by Detlev Zundel, 15 Jan 2003: Fix '' command line quoting * Patch by The LEOX team, 19 Jan 2003: - add support for the ELPT860 board - add support for Dallas ds164x RTC
*	* Add dual ethernet support on PM826	wdenk	2003-01-17	-1/+1
\| \| \| \| \| \| \| \| \| \|	* Add support for LXT971 PHY on PM826 * Patch by Tord Andersson, 16 Jan 2003: Fix flash sector count for TQM8xxL * Fix I2C EEPROM problem on ICU862 board (would only write the first 16 bytes out of each 32 byte block)
*	* Use 1-byte-read instead of -write for iprobe() function	wdenk	2002-12-17	-16/+40
\| \| \| \| \| \|	Add i2c commands to PM826 config * extend I2C POST code: check for list on known addresses
*	Initial revision	wdenk	2002-10-02	-0/+445