summaryrefslogtreecommitdiff
path: root/include/configs/MPC8572DS.h
Commit message (Collapse)AuthorAgeLines
* NAND: Fix CONFIG_ENV_ADDR for MPC8572DSHaiying Wang2008-10-31-1/+1
| | | | | | | CONFIG_ENV_ADDR should be (CONFIG_SYS_MONITOR_BASE - CONFIG_ENV_SECT_SIZE). Signed-off-by: Haiying Wang <Haiying.Wang@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
* NAND: Add support for MPC8572DS boardHaiying Wang2008-10-29-1/+55
| | | | | | | | | | | | | This patch defines 1M TLB&LAW size for NAND on MPC8572DS, assigns 0xffa00000 for CONFIG_SYS_NAND_BASE and adds other NAND supports in config file. It also moves environment(CONFIG_ENV_ADDR) outside of u-boot image, to make room for the increased code size with NAND enabled. Signed-off-by: Jason Jin <Jason.Jin@freescale.com> Signed-off-by: Haiying Wang <Haiying.Wang@freescale.com> Signed-off-by: Scott Wood <scottwood@freescale.com>
* 85xx: Convert all fsl_pci_init users to new APIsKumar Gala2008-10-24-5/+0
| | | | | | | | | | | | Converted ATUM8548, MPC8536DS, MPC8544DS, MPC8548CDS, MPC8568MDS, MPC8572DS, TQM85xx, and SBC8548 to use fsl_pci_setup_inbound_windows() and ft_fsl_pci_setup(). With these changes the board code is a bit smaller and we get dma-ranges set in the device tree for these boards. Signed-off-by: Kumar Gala <galak@kernel.crashing.org> Signed-off-by: Andrew Fleming-AFLEMING <afleming@freescale.com>
* 85xx: Enable 64-bit PCI resources on all Freescale boardsKumar Gala2008-10-24-0/+1
| | | | | Signed-off-by: Kumar Gala <galak@kernel.crashing.org> Signed-off-by: Andrew Fleming-AFLEMING <afleming@freescale.com>
* 85xx: remove unused config definitionDave Liu2008-10-24-10/+0
| | | | Signed-off-by: Dave Liu <daveliu@freescale.com>
* Enabled the Freescale SGMII riser card on 8572DSLiu Yu2008-10-18-0/+24
| | | | | | | This patch based on Andy's work. Including command 'pixis_set_sgmii' support. Signed-off-by: Liu Yu <yu.liu@freescale.com>
* Add ddr interleaving suppport for MPC8572DS boardHaiying Wang2008-10-18-1/+2
| | | | | | | | | | | | | | | | * Add board specific parameter table to choose correct cpo, clk_adjust, write_data_delay, 2T based on board ddr frequency and n_ranks. * Set odt_rd_cfg and odt_wr_cfg based on the dimm# and CS#. * Set memory controller interleaving mode to bank interleaving, and disable bank(chip select) interleaving mode by default, because the default on-board DDR DIMMs are 2x512MB single-rank. * Change CONFIG_ICS307_REFCLK_HZ from 33333333 to 33333000. Signed-off-by: James Yang <James.Yang@freescale.com> Signed-off-by: Haiying Wang <Haiying.Wang@freescale.com>
* 85xx: Enable interrupt and setexpr commands on Freescale 85xx boardsKumar Gala2008-10-18-0/+2
| | | | Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
* rename CFG_ macros to CONFIG_SYSJean-Christophe PLAGNIOL-VILLARD2008-10-18-129/+129
| | | | Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
* MPC8572DS: Fix compile warningsKumar Gala2008-10-08-1/+1
| | | | | | | | | | Commit 445a7b38308eb05b41de74165b20855db58c7ee5 introduced the following compile warnings: cmd_i2c.c:112: warning: missing braces around initializer cmd_i2c.c:112: warning: (near initialization for 'i2c_no_probes[0]') Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
* Add ID EEPROM support for MPC8572DSHaiying Wang2008-10-07-0/+11
| | | | | | | The ID EEPROM on MPC8572DS board locates on I2C bus 1. Its the storage for system information like mac addresses etc. This patch enables it. Signed-off-by: Haiying Wang <Haiying.Wang@freescale.com>
* Minor fixes for I2C address on MPC8572DSHaiying Wang2008-10-07-2/+6
| | | | | | | MPC8572DS has two i2c buses. This patch moves the DDR SPD_EEPROM to i2c bus 1 according to the board spec, and adds the 2nd i2c bus offset. Signed-off-by: Haiying Wang <Haiying.Wang@freescale.com>
* rename CFG_ENV macros to CONFIG_ENVJean-Christophe PLAGNIOL-VILLARD2008-09-10-4/+4
| | | | Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
* rename CFG_ENV_IS_IN_FLASH in CONFIG_ENV_IS_IN_FLASHJean-Christophe PLAGNIOL-VILLARD2008-09-10-1/+1
| | | | Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
* mpc85xx: Add support for the MPC8572DS reference boardKumar Gala2008-08-27-0/+576
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
generated by cgit v1.1 at 2024-11-07 10:39:16 +0000