arm-boot/u-boot-imx.git - U-boot NXP imx6

	Commit message (Collapse)	Author	Age	Lines
*	mmc: Move atmel_mci driver into drivers/mmc	Haavard Skinnemoen	2008-07-10	-548/+0
\| \| \| \| \| \| \|	This makes it easier to use the driver on other platforms. Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com> Acked-by: Jean-Chritophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
*	MMC: Consolidate MMC/SD command definitions	Haavard Skinnemoen	2008-06-28	-2/+2
\| \| \| \| \| \| \| \| \| \| \| \| \| \| \|	This moves the MMC and SD Card command definitions from include/asm/arch/mmc.h into include/mmc.h. These definitions are given by the MMC and SD Card standards, not by any particular architecture. There's a lot more room for consolidation in the MMC drivers which I'm hoping to get done eventually, but this patch is a start. Compile-tested for all avr32 boards as well as lpc2292sodimm and lubbock. This should cover all three mmc drivers in the tree. Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
*	avr32: Compile atmel_mci.o conditionally	Haavard Skinnemoen	2008-05-27	-4/+0
\| \| \| \| \| \| \|	Remove #ifdef CONFIG_MMC from the source file and use conditional compilation in the Makefile instead. Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
*	avr32: Fix wrong error flags in atmel_mci driver	Haavard Skinnemoen	2008-05-27	-1/+1
\| \| \| \| \| \| \| \|	Make sure we check for CRC errors when sending commands that use CRC checking. Reported-by: Gururaja Hebbar K R <gururajakr@sanyo.co.in> Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
*	avr32: Fix two warnings in atmel_mci.c	Haavard Skinnemoen	2008-05-27	-2/+4
\| \| \| \| \| \|	The warnings are harmless but annoying. Let's fix them. Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
*	atmel_mci: Show SR when block read fails	Haavard Skinnemoen	2007-12-17	-6/+7
\| \| \| \| \| \| \|	Show controller status as well as card status when an error occurs during block read. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
*	atmel_mci: Fix data timeout value	Haavard Skinnemoen	2007-08-13	-0/+59
\| \| \| \| \| \| \| \| \|	Calculate the data timeout based on values from the CSD instead of just using a hardcoded DTOR value. This is a backport of a similar fix in BSP 2.0, with one additional fix: the DTOCYC value is rounded up instead of down. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
*	atmel_mci: Use 512 byte blocksize if possible	Haavard Skinnemoen	2007-08-13	-4/+17
\| \| \| \| \| \| \| \| \| \| \| \|	Instead of always using the largest blocksize the card supports, check if it can support smaller block sizes and use 512 bytes if possible. Most cards do support this, and other parts of u-boot seem to have trouble with block sizes different from 512 bytes. Also enable underrun/overrun protection. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com> Acked-by: Hans-Christian Egtvedt <hcegtvedt@atmel.com>
*	Merge with /home/wd/git/u-boot/custodian/u-boot-avr32; code cleanup.	Wolfgang Denk	2007-04-18	-1/+1
\|
*	Atmel MCI driver	Haavard Skinnemoen	2007-04-14	-0/+477
	Driver for the Atmel MCI controller (MMC interface) for AT32AP CPUs. The AT91 ARM-based CPUs use basically the same hardware, so it should be possible to share this driver, but no effort has been made so far. Hardware documentation can be found in the AT32AP7000 data sheet, which can be downloaded from http://www.atmel.com/dyn/products/datasheets.asp?family_id=682 Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>