| Commit message (Collapse) | Author | Age | Lines |
|
|
|
|
|
|
|
|
|
| |
Set the ID pin pad to pull up not the pull down at default, otherwise
we can't enter the device mode, but always detect as host.
After this change we have to use portA cable to play as host,
and use portB cable for device.
Signed-off-by: Ye.Li <B37916@freescale.com>
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
1. Add weimnor boot defconfig
2. move CONFIG_FSL_USDHC and CONFIG_VIDEO to board header
3. Add CONFIG_SYS_FLASH_PROTECTION for mx6ul 14x14 lpddr2 arm2
4. correct CONFIG_SYS_FLASH_SECT_SIZE and CONFIG_SYS_MAX_FLASH_SECT
5. Add comments for setup_eimnor, since ENET2_RXER pin conflicts
with ENET2. Also eimnor support will disable SD1/SD2, need ENET
to boot kernel and nfs using enet. So setup_eimnor should be
invoked after setup_fec
Signed-off-by: Peng Fan <Peng.Fan@freescale.com>
|
|
|
|
|
|
|
|
| |
The current pad DSE for QSPI is 60ohm. Per hardware team measurement,
this setting cause too strong drive to clock and data signals. Need
to change the DSE to 120ohm for better signal quality.
Signed-off-by: Ye.Li <B37916@freescale.com>
|
|
Add MX6UL LPDDR2 ARM2 board BSP codes, supported peripherals:
SD1, eMMC(USDHC2), USB OTG1, I2C, ENET2, PMIC.
Due to a board issue, the SD1 only supports 1 bit bus width.
Signed-off-by: Ye.Li <B37916@freescale.com>
|