| Commit message (Expand) | Author | Age | Lines |
|---|
| * | arm: sama5d3: remove unused define | Bo Shen | 2013-08-22 | -2/+0 |
| * | arm: sama5d3: fix smc cs related registers offset | Bo Shen | 2013-08-22 | -1/+1 |
| * | ARM: at91: atmel_nand: add code to check the ONFI parameter ECC requirement | Wu, Josh | 2013-08-22 | -2/+128 |
| * | mtd: atmel_nand: alloc memory instead of use static array for pmecc data | Wu, Josh | 2013-08-22 | -7/+56 |
| * | linux/compat.h: move dev_err, dev_info and dev_dbg from usb driver to compat.h | Wu, Josh | 2013-08-22 | -16/+8 |
| * | ARM: at91: sama5d3: remove unused definition about PMECC alpha table offset | Wu, Josh | 2013-08-22 | -2/+0 |
| * | ARM: at91: atmel_nand: pmecc driver will select the galois table by sector size | Wu, Josh | 2013-08-22 | -17/+10 |
| * | arm: atmel: add nand trimffs subcommand for at91sam9n12 and at91sam9x5 | Bo Shen | 2013-08-22 | -0/+5 |
| * | arm: atmel: add gmac support for sama5d3xek board | Bo Shen | 2013-08-22 | -0/+50 |
| * | net: macb: fix the following building warning | Bo Shen | 2013-08-22 | -3/+9 |
| * | Merge branch 'u-boot-imx/master' into 'u-boot-arm/master' | Albert ARIBAUD | 2013-08-17 | -1966/+601 |
| |\ |
|
| | * | Merge git://git.denx.de/u-boot-arm | Stefano Babic | 2013-07-31 | -95031/+13229 |
| | |\ |
|
| | * | | mxc_ipuv3: fix memory alignment of framebuffer | Eric Nelson | 2013-07-29 | -2/+3 |
| | * | | imx: nitrogen6x: mx6qsabrelite: Add support for DVI monitors | Robert Winkler | 2013-07-27 | -3/+5 |
| | * | | imx: Add documentation for imx specific commands | Robert Winkler | 2013-07-27 | -0/+15 |
| | * | | mx6qsabresd: Add splash screen support via HDMI | Pardeep Kumar Singla | 2013-07-27 | -2/+84 |
| | * | | mx6: Factor out common HDMI setup code | Pardeep Kumar Singla | 2013-07-27 | -78/+70 |
| | * | | mx6qsabrelite: Remove mx6qsabrelite code in favor of nitrogen6x | Fabio Estevam | 2013-07-26 | -1189/+81 |
| | * | | wandboard: Use splash image at screen center by default | Otavio Salvador | 2013-07-24 | -0/+1 |
| | * | | mxc_gpio: Correct the GPIO handling in gpio_direction_output() | Dirk Behme | 2013-07-24 | -2/+2 |
| | * | | ARM: mxs: Consolidate configuration options | Marek Vasut | 2013-07-24 | -732/+340 |
| * | | | Add TI816X evm board support | TENART Antoine | 2013-08-15 | -0/+451 |
| * | | | Add TI816X support | TENART Antoine | 2013-08-15 | -117/+1076 |
| * | | | Prepare for TI816X : reuse existing code from TI814X | TENART Antoine | 2013-08-15 | -4/+4 |
| * | | | arm, da850: add ipam390 board support | Heiko Schocher | 2013-08-15 | -0/+1194 |
| * | | | arm, da850: enable the correct uart in arch_cpu_init() | Heiko Schocher | 2013-08-15 | -0/+4 |
| * | | | bootstage: get more BOOTSTAGE_ID* in show_boot_progress() | Heiko Schocher | 2013-08-15 | -0/+1 |
| * | | | arm/davinci/da850: add uart0_pins_rtscts and RMII_MHz_50_CLK in emac_pins_rmi... | Heiko Schocher | 2013-08-15 | -1/+8 |
| * | | | TI:armv7: Enable CONFIG_CMD_GPIO | Tom Rini | 2013-08-15 | -0/+1 |
| * | | | TI:armv7: Enable CONFIG_CMD_SPI | Tom Rini | 2013-08-15 | -0/+1 |
| * | | | TI:omap5/dra7xx: Convert to ti_armv7_common.h | Tom Rini | 2013-08-15 | -177/+34 |
| * | | | TI:am33xx: Create common config files for TI ARMv7 platforms, and AM33xx | Tom Rini | 2013-08-15 | -218/+326 |
| * | | | am335x_evm: Bring in 'boot_fdt' logic from i.MX | Tom Rini | 2013-08-15 | -5/+16 |
| * | | | arm: spl: For Falcon Mode, set a default machid of ~0 | Tom Rini | 2013-08-15 | -1/+6 |
| * | | | am335x_evm: Use default baud rate table | Tom Rini | 2013-08-15 | -2/+0 |
| * | | | am33xx: Stop using PHYS_DRAM_1 define | Tom Rini | 2013-08-15 | -12/+9 |
| * | | | am33xx: CONFIG_DMA_COHERENT defines are unused, remove | Tom Rini | 2013-08-15 | -10/+0 |
| * | | | OMAP3: igep00x0: allow booting with a FDT from MMC | Javier Martinez Canillas | 2013-08-15 | -1/+26 |
| * | | | ARM: igep00x0.h: Enable the use of CMD_EXT4, CMD_FS_GENERIC and zImage. | Enric Balletbo i Serra | 2013-08-15 | -6/+7 |
| * | | | omap: emif: Set initial DDR PHY config first | Taras Kondratiuk | 2013-08-15 | -1/+1 |
| * | | | ARM: omap24xx: remove remainders of dead board | Masahiro Yamada | 2013-08-15 | -193/+0 |
| * | | | ARM: omap3: Implement dpll5 (HSUSB clk) workaround for OMAP36xx/AM/DM37xx acc... | Naumann Andreas | 2013-08-15 | -1/+60 |
| * | | | omap: overo: Use 200MHz SDRC timings for revision 1, 2 & 3 boards | Ash Charles | 2013-08-15 | -8/+8 |
| * | | | omap: overo: update support for Micron 1GB POP | Steve Sakoman | 2013-08-15 | -0/+7 |
| * | | | ARM: IGEP0033: Remove duplicate / unused #defines. | Enric Balletbo i Serra | 2013-08-15 | -7/+1 |
| * | | | ARM: IGEP0033: Add support to boot from NAND. | Enric Balletbo i Serra | 2013-08-15 | -5/+27 |
| * | | | ARM: IGEP0033: Remove CYGNUS name from header. | Enric Balletbo i Serra | 2013-08-15 | -2/+2 |
| * | | | ARM: IGEP0033: Add support for Flattened Device Tree. | Enric Balletbò i Serra | 2013-08-15 | -20/+13 |
| * | | | ARM: IGEP0033: Remove undef of CONFIG_CMD_MEMTEST | Enric Balletbo i Serra | 2013-08-15 | -7/+0 |
| * | | | ARM: AM43xx: Add config file | Lokesh Vutla | 2013-08-15 | -0/+136 |
