diff options
Diffstat (limited to 'include/configs')
| -rw-r--r-- | include/configs/katmai.h | 7 | ||||
| -rw-r--r-- | include/configs/korat.h | 11 |
2 files changed, 14 insertions, 4 deletions
diff --git a/include/configs/katmai.h b/include/configs/katmai.h index d3789bd..f07e470 100644 --- a/include/configs/katmai.h +++ b/include/configs/katmai.h @@ -41,6 +41,13 @@ #define CFG_4xx_RESET_TYPE 0x2 /* use chip reset on this board */ /* + * Enable this board for more than 2GB of SDRAM + */ +#define CONFIG_PHYS_64BIT +#define CONFIG_VERY_BIG_RAM +#define CONFIG_MAX_MEM_MAPPED ((phys_size_t)2 << 30) + +/* * Include common defines/options for all AMCC eval boards */ #define CONFIG_HOSTNAME katmai diff --git a/include/configs/korat.h b/include/configs/korat.h index 7655666..4ca4ed0 100644 --- a/include/configs/korat.h +++ b/include/configs/korat.h @@ -129,7 +129,7 @@ #define CFG_ENV_SECT_SIZE 0x20000 /* size of one complete sector */ #define CFG_ENV_ADDR (CFG_FLASH1_TOP - CFG_ENV_SECT_SIZE) -#define CFG_ENV_SIZE 0x2000 /* Total Size of Environment Sector */ +#define CFG_ENV_SIZE 0x2000 /* Total Size of Environment Sector */ /* Address and size of Redundant Environment Sector */ #define CFG_ENV_ADDR_REDUND (CFG_ENV_ADDR - CFG_ENV_SECT_SIZE) @@ -145,7 +145,6 @@ #define CONFIG_DDR_ECC /* Use ECC when available */ #define SPD_EEPROM_ADDRESS {0x50} #define CONFIG_PROG_SDRAM_TLB -#define CFG_DRAM_TEST #define CFG_MEM_TOP_HIDE (4 << 10) /* don't use last 4kbytes */ /* 440EPx errata CHIP 11 */ @@ -185,7 +184,7 @@ #define CFG_ROOTPATH "rootpath=/opt/eldk/ppc_4xxFP\0" /* Note: kernel_addr and ramdisk_addr assume that FLASH1 is 64 MiB. */ -#define CONFIG_EXTRA_ENV_SETTINGS \ +#define CONFIG_EXTRA_ENV_SETTINGS \ CFG_BOOTFILE \ CFG_ROOTPATH \ "netdev=eth0\0" \ @@ -216,7 +215,7 @@ #define CONFIG_LOADS_ECHO 1 /* echo on for serial download */ #define CFG_LOADS_BAUD_CHANGE 1 /* allow baudrate change */ -#define CONFIG_IBM_EMAC4_V4 1 +#define CONFIG_IBM_EMAC4_V4 1 #define CONFIG_MII 1 /* MII PHY management */ #define CONFIG_PHY_ADDR 2 /* PHY address, See schematics */ #define CONFIG_PHY_DYNAMIC_ANEG 1 @@ -548,4 +547,8 @@ #define CONFIG_KGDB_SER_INDEX 2 /* which serial port to use */ #endif +/* Pass open firmware flat tree */ +#define CONFIG_OF_LIBFDT 1 +#define CONFIG_OF_BOARD_SETUP 1 + #endif /* __CONFIG_H */ |