diff options
Diffstat (limited to 'include/configs/socfpga_common.h')
| -rw-r--r-- | include/configs/socfpga_common.h | 46 |
1 files changed, 46 insertions, 0 deletions
diff --git a/include/configs/socfpga_common.h b/include/configs/socfpga_common.h index e1aae49..c436fda 100644 --- a/include/configs/socfpga_common.h +++ b/include/configs/socfpga_common.h @@ -79,6 +79,25 @@ #define CONFIG_SYS_PL310_BASE SOCFPGA_MPUL2_ADDRESS /* + * EPCS/EPCQx1 Serial Flash Controller + */ +#ifdef CONFIG_ALTERA_SPI +#define CONFIG_CMD_SPI +#define CONFIG_CMD_SF +#define CONFIG_SF_DEFAULT_SPEED 30000000 +#define CONFIG_SPI_FLASH +#define CONFIG_SPI_FLASH_STMICRO +#define CONFIG_SPI_FLASH_BAR +/* + * The base address is configurable in QSys, each board must specify the + * base address based on it's particular FPGA configuration. Please note + * that the address here is incremented by 0x400 from the Base address + * selected in QSys, since the SPI registers are at offset +0x400. + * #define CONFIG_SYS_SPI_BASE 0xff240400 + */ +#endif + +/* * Ethernet on SoC (EMAC) */ #if defined(CONFIG_CMD_NET) && !defined(CONFIG_SOCFPGA_VIRTUAL_TARGET) @@ -141,6 +160,33 @@ #define CONFIG_SYS_MMC_MAX_BLK_COUNT 256 /* FIXME -- SPL only? */ #endif + /* + * I2C support + */ +#define CONFIG_SYS_I2C +#define CONFIG_SYS_I2C_DW +#define CONFIG_SYS_I2C_BUS_MAX 4 +#define CONFIG_SYS_I2C_BASE SOCFPGA_I2C0_ADDRESS +#define CONFIG_SYS_I2C_BASE1 SOCFPGA_I2C1_ADDRESS +#define CONFIG_SYS_I2C_BASE2 SOCFPGA_I2C2_ADDRESS +#define CONFIG_SYS_I2C_BASE3 SOCFPGA_I2C3_ADDRESS +/* Using standard mode which the speed up to 100Kb/s */ +#define CONFIG_SYS_I2C_SPEED 100000 +#define CONFIG_SYS_I2C_SPEED1 100000 +#define CONFIG_SYS_I2C_SPEED2 100000 +#define CONFIG_SYS_I2C_SPEED3 100000 +/* Address of device when used as slave */ +#define CONFIG_SYS_I2C_SLAVE 0x02 +#define CONFIG_SYS_I2C_SLAVE1 0x02 +#define CONFIG_SYS_I2C_SLAVE2 0x02 +#define CONFIG_SYS_I2C_SLAVE3 0x02 +#ifndef __ASSEMBLY__ +/* Clock supplied to I2C controller in unit of MHz */ +unsigned int cm_get_l4_sp_clk_hz(void); +#define IC_CLK (cm_get_l4_sp_clk_hz() / 1000000) +#endif +#define CONFIG_CMD_I2C + /* * Serial Driver */ |