diff options
Diffstat (limited to 'include/configs/cm5200.h')
| -rw-r--r-- | include/configs/cm5200.h | 126 |
1 files changed, 63 insertions, 63 deletions
diff --git a/include/configs/cm5200.h b/include/configs/cm5200.h index 0221dfe..620ffea 100644 --- a/include/configs/cm5200.h +++ b/include/configs/cm5200.h @@ -58,7 +58,7 @@ */ #define CONFIG_PSC_CONSOLE 1 /* console is on PSC1 */ #define CONFIG_BAUDRATE 57600 /* ... at 57600 bps */ -#define CFG_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200, 230400 } +#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200, 230400 } #define CONFIG_SILENT_CONSOLE 1 /* needed to silence i2c_init() */ /* @@ -67,17 +67,17 @@ #define CONFIG_MPC5xxx_FEC 1 #define CONFIG_PHY_ADDR 0x00 #define CONFIG_ENV_OVERWRITE 1 /* allow overwriting of ethaddr */ -/* use misc_init_r() to read ethaddr from I2C EEPROM (see CFG_I2C_EEPROM) */ +/* use misc_init_r() to read ethaddr from I2C EEPROM (see CONFIG_SYS_I2C_EEPROM) */ #define CONFIG_MISC_INIT_R 1 #define CONFIG_MAC_OFFSET 0x35 /* MAC address offset in I2C EEPROM */ /* * POST support */ -#define CONFIG_POST (CFG_POST_MEMORY | CFG_POST_CPU | CFG_POST_I2C) +#define CONFIG_POST (CONFIG_SYS_POST_MEMORY | CONFIG_SYS_POST_CPU | CONFIG_SYS_POST_I2C) #define MPC5XXX_SRAM_POST_SIZE (MPC5XXX_SRAM_SIZE - 4) /* List of I2C addresses to be verified by POST */ -#define I2C_ADDR_LIST { CFG_I2C_SLAVE, CFG_I2C_IO, CFG_I2C_EEPROM } +#define I2C_ADDR_LIST { CONFIG_SYS_I2C_SLAVE, CONFIG_SYS_I2C_IO, CONFIG_SYS_I2C_EEPROM } /* display image timestamps */ #define CONFIG_TIMESTAMP 1 @@ -141,53 +141,53 @@ /* * Clock configuration */ -#define CFG_MPC5XXX_CLKIN 33000000 /* SYS_XTAL_IN = 33MHz */ -#define CFG_IPBCLK_EQUALS_XLBCLK 1 /* IPB = 133MHz */ +#define CONFIG_SYS_MPC5XXX_CLKIN 33000000 /* SYS_XTAL_IN = 33MHz */ +#define CONFIG_SYS_IPBCLK_EQUALS_XLBCLK 1 /* IPB = 133MHz */ /* * Memory map */ -#define CFG_MBAR 0xF0000000 -#define CFG_SDRAM_BASE 0x00000000 -#define CFG_DEFAULT_MBAR 0x80000000 +#define CONFIG_SYS_MBAR 0xF0000000 +#define CONFIG_SYS_SDRAM_BASE 0x00000000 +#define CONFIG_SYS_DEFAULT_MBAR 0x80000000 -#define CFG_LOWBOOT 1 +#define CONFIG_SYS_LOWBOOT 1 /* Use ON-Chip SRAM until RAM will be available */ -#define CFG_INIT_RAM_ADDR MPC5XXX_SRAM +#define CONFIG_SYS_INIT_RAM_ADDR MPC5XXX_SRAM #ifdef CONFIG_POST /* preserve space for the post_word at end of on-chip SRAM */ -#define CFG_INIT_RAM_END MPC5XXX_SRAM_POST_SIZE +#define CONFIG_SYS_INIT_RAM_END MPC5XXX_SRAM_POST_SIZE #else -#define CFG_INIT_RAM_END MPC5XXX_SRAM_SIZE +#define CONFIG_SYS_INIT_RAM_END MPC5XXX_SRAM_SIZE #endif -#define CFG_GBL_DATA_SIZE 128 /* size in bytes for initial data */ -#define CFG_GBL_DATA_OFFSET (CFG_INIT_RAM_END - CFG_GBL_DATA_SIZE) +#define CONFIG_SYS_GBL_DATA_SIZE 128 /* size in bytes for initial data */ +#define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE) #define CONFIG_BOARD_TYPES 1 /* we use board_type */ -#define CFG_INIT_SP_OFFSET CFG_GBL_DATA_OFFSET +#define CONFIG_SYS_INIT_SP_OFFSET CONFIG_SYS_GBL_DATA_OFFSET -#define CFG_MONITOR_BASE TEXT_BASE -#define CFG_MONITOR_LEN (384 << 10) /* 384 kB for Monitor */ -#define CFG_MALLOC_LEN (256 << 10) /* 256 kB for malloc() */ -#define CFG_BOOTMAPSZ (8 << 20) /* initial mem map for Linux */ +#define CONFIG_SYS_MONITOR_BASE TEXT_BASE +#define CONFIG_SYS_MONITOR_LEN (384 << 10) /* 384 kB for Monitor */ +#define CONFIG_SYS_MALLOC_LEN (256 << 10) /* 256 kB for malloc() */ +#define CONFIG_SYS_BOOTMAPSZ (8 << 20) /* initial mem map for Linux */ /* * Flash configuration */ -#define CFG_FLASH_CFI 1 +#define CONFIG_SYS_FLASH_CFI 1 #define CONFIG_FLASH_CFI_DRIVER 1 -#define CFG_FLASH_BASE 0xfc000000 +#define CONFIG_SYS_FLASH_BASE 0xfc000000 /* we need these despite using CFI */ -#define CFG_MAX_FLASH_BANKS 1 /* max num of flash banks */ -#define CFG_MAX_FLASH_SECT 256 /* max num of sectors on one chip */ -#define CFG_FLASH_SIZE 0x02000000 /* 32 MiB */ +#define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max num of flash banks */ +#define CONFIG_SYS_MAX_FLASH_SECT 256 /* max num of sectors on one chip */ +#define CONFIG_SYS_FLASH_SIZE 0x02000000 /* 32 MiB */ -#if (CFG_MONITOR_BASE < CFG_FLASH_BASE) -#define CFG_RAMBOOT 1 -#undef CFG_LOWBOOT +#if (CONFIG_SYS_MONITOR_BASE < CONFIG_SYS_FLASH_BASE) +#define CONFIG_SYS_RAMBOOT 1 +#undef CONFIG_SYS_LOWBOOT #endif @@ -195,19 +195,19 @@ * Chip selects configuration */ /* Boot Chipselect */ -#define CFG_BOOTCS_START CFG_FLASH_BASE -#define CFG_BOOTCS_SIZE CFG_FLASH_SIZE -#define CFG_BOOTCS_CFG 0x00087D31 /* for pci_clk = 33 MHz */ +#define CONFIG_SYS_BOOTCS_START CONFIG_SYS_FLASH_BASE +#define CONFIG_SYS_BOOTCS_SIZE CONFIG_SYS_FLASH_SIZE +#define CONFIG_SYS_BOOTCS_CFG 0x00087D31 /* for pci_clk = 33 MHz */ /* use board_early_init_r to enable flash write in CS_BOOT */ #define CONFIG_BOARD_EARLY_INIT_R /* Flash memory addressing */ -#define CFG_CS0_START CFG_FLASH_BASE -#define CFG_CS0_SIZE CFG_FLASH_SIZE +#define CONFIG_SYS_CS0_START CONFIG_SYS_FLASH_BASE +#define CONFIG_SYS_CS0_SIZE CONFIG_SYS_FLASH_SIZE /* No burst, dead cycle = 1 for CS0 (Flash) */ -#define CFG_CS_BURST 0x00000000 -#define CFG_CS_DEADCYCLE 0x00000001 +#define CONFIG_SYS_CS_BURST 0x00000000 +#define CONFIG_SYS_CS_DEADCYCLE 0x00000001 /* * SDRAM configuration @@ -233,11 +233,11 @@ * I2C configuration */ #define CONFIG_HARD_I2C 1 /* I2C with hardware support */ -#define CFG_I2C_MODULE 2 /* Select I2C module #2 */ -#define CFG_I2C_SPEED 40000 /* 40 kHz */ -#define CFG_I2C_SLAVE 0x0 -#define CFG_I2C_IO 0x38 /* PCA9554AD I2C I/O port address */ -#define CFG_I2C_EEPROM 0x53 /* I2C EEPROM device address */ +#define CONFIG_SYS_I2C_MODULE 2 /* Select I2C module #2 */ +#define CONFIG_SYS_I2C_SPEED 40000 /* 40 kHz */ +#define CONFIG_SYS_I2C_SLAVE 0x0 +#define CONFIG_SYS_I2C_IO 0x38 /* PCA9554AD I2C I/O port address */ +#define CONFIG_SYS_I2C_EEPROM 0x53 /* I2C EEPROM device address */ /* * RTC configuration @@ -264,13 +264,13 @@ /* * Environment settings */ -#define CFG_ENV_IS_IN_FLASH 1 -#define CFG_ENV_SIZE 0x10000 -#define CFG_ENV_SECT_SIZE 0x20000 -#define CFG_ENV_ADDR (CFG_FLASH_BASE + CFG_MONITOR_LEN) +#define CONFIG_ENV_IS_IN_FLASH 1 +#define CONFIG_ENV_SIZE 0x10000 +#define CONFIG_ENV_SECT_SIZE 0x20000 +#define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN) /* Configuration of redundant environment */ -#define CFG_ENV_ADDR_REDUND (CFG_ENV_ADDR + CFG_ENV_SECT_SIZE) -#define CFG_ENV_SIZE_REDUND (CFG_ENV_SIZE) +#define CONFIG_ENV_ADDR_REDUND (CONFIG_ENV_ADDR + CONFIG_ENV_SECT_SIZE) +#define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SIZE) /* * Pin multiplexing configuration @@ -287,44 +287,44 @@ * PSC2: UART * PSC1: UART */ -#define CFG_GPS_PORT_CONFIG 0x10559C44 +#define CONFIG_SYS_GPS_PORT_CONFIG 0x10559C44 /* * Miscellaneous configurable options */ -#define CFG_LONGHELP 1 /* undef to save memory */ -#define CFG_PROMPT "=> " /* Monitor Command Prompt */ -#define CFG_CBSIZE 1024 /* Console I/O Buffer Size */ -#define CFG_PBSIZE (CFG_CBSIZE+sizeof(CFG_PROMPT)+16) /* Print Buffer Size */ -#define CFG_MAXARGS 16 /* max number of command args */ -#define CFG_BARGSIZE CFG_CBSIZE /* Boot Argument Buffer Size */ +#define CONFIG_SYS_LONGHELP 1 /* undef to save memory */ +#define CONFIG_SYS_PROMPT "=> " /* Monitor Command Prompt */ +#define CONFIG_SYS_CBSIZE 1024 /* Console I/O Buffer Size */ +#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */ +#define CONFIG_SYS_MAXARGS 16 /* max number of command args */ +#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */ -#define CFG_ALT_MEMTEST 1 -#define CFG_MEMTEST_START 0x00100000 /* memtest works on */ -#define CFG_MEMTEST_END 0x03f00000 /* 1 .. 63 MiB in SDRAM */ +#define CONFIG_SYS_ALT_MEMTEST 1 +#define CONFIG_SYS_MEMTEST_START 0x00100000 /* memtest works on */ +#define CONFIG_SYS_MEMTEST_END 0x03f00000 /* 1 .. 63 MiB in SDRAM */ #define CONFIG_LOOPW 1 -#define CFG_LOAD_ADDR 0x100000 /* default load address */ -#define CFG_HZ 1000 /* decrementer freq: 1 ms ticks */ +#define CONFIG_SYS_LOAD_ADDR 0x100000 /* default load address */ +#define CONFIG_SYS_HZ 1000 /* decrementer freq: 1 ms ticks */ /* * Various low-level settings */ -#define CFG_HID0_INIT HID0_ICE | HID0_ICFI -#define CFG_HID0_FINAL HID0_ICE +#define CONFIG_SYS_HID0_INIT HID0_ICE | HID0_ICFI +#define CONFIG_SYS_HID0_FINAL HID0_ICE #define BOOTFLAG_COLD 0x01 /* Normal Power-On: Boot from FLASH */ #define BOOTFLAG_WARM 0x02 /* Software reboot */ -#define CFG_XLB_PIPELINING 1 /* enable transaction pipeling */ +#define CONFIG_SYS_XLB_PIPELINING 1 /* enable transaction pipeling */ /* * Cache Configuration */ -#define CFG_CACHELINE_SIZE 32 /* For MPC5xxx CPUs */ +#define CONFIG_SYS_CACHELINE_SIZE 32 /* For MPC5xxx CPUs */ #ifdef CONFIG_CMD_KGDB -#define CFG_CACHELINE_SHIFT 5 /* log base 2 of the above value */ +#define CONFIG_SYS_CACHELINE_SHIFT 5 /* log base 2 of the above value */ #endif /* |