diff options
Diffstat (limited to 'include/configs/PMC405.h')
| -rw-r--r-- | include/configs/PMC405.h | 42 |
1 files changed, 34 insertions, 8 deletions
diff --git a/include/configs/PMC405.h b/include/configs/PMC405.h index 8bcab0b..6e0bd7f 100644 --- a/include/configs/PMC405.h +++ b/include/configs/PMC405.h @@ -53,9 +53,15 @@ #define CONFIG_LOADS_ECHO 1 /* echo on for serial download */ #define CFG_LOADS_BAUD_CHANGE 1 /* allow baudrate change */ +#define CONFIG_NET_MULTI 1 +#undef CONFIG_HAS_ETH1 + #define CONFIG_MII 1 /* MII PHY management */ #define CONFIG_PHY_ADDR 0 /* PHY address */ #define CONFIG_LXT971_NO_SLEEP 1 /* disable sleep mode in LXT971 */ +#define CONFIG_RESET_PHY_R 1 /* use reset_phy() to disable phy sleep mode */ + +#define CONFIG_NETCONSOLE /* include NetConsole support */ #define CONFIG_COMMANDS ( CONFIG_CMD_DFL | \ CFG_CMD_BSP | \ @@ -154,15 +160,24 @@ #define CONFIG_PCI_BOOTDELAY 0 /* enable pci bootdelay variable*/ #define CFG_PCI_SUBSYS_VENDORID 0x12FE /* PCI Vendor ID: esd gmbh */ -#define CFG_PCI_SUBSYS_DEVICEID 0x0408 /* PCI Device ID: PMC-405 */ +#define CFG_PCI_SUBSYS_DEVICEID_NONMONARCH 0x0408 /* PCI Device ID: Non-Monarch */ +#define CFG_PCI_SUBSYS_DEVICEID_MONARCH 0x0409 /* PCI Device ID: Monarch */ +#define CFG_PCI_SUBSYS_DEVICEID pmc405_pci_subsys_deviceid() + #define CFG_PCI_CLASSCODE 0x0b20 /* PCI Class Code: Processor/PPC*/ -#define CFG_PCI_PTM1LA 0x00000000 /* point to sdram */ -#define CFG_PCI_PTM1MS 0xfc000001 /* 64MB, enable hard-wired to 1 */ + +#define CFG_PCI_PTM1LA (bd->bi_memstart) /* point to sdram */ +#define CFG_PCI_PTM1MS (~(bd->bi_memsize - 1) | 1) /* memsize, enable hard-wired to 1 */ #define CFG_PCI_PTM1PCI 0x00000000 /* Host: use this pci address */ +#if 1 +#define CFG_PCI_PTM2LA 0xef000000 /* point to internal regs */ +#define CFG_PCI_PTM2MS 0xff000001 /* 16MB, enable */ +#define CFG_PCI_PTM2PCI 0x00000000 /* Host: use this pci address */ +#else /* old mapping */ #define CFG_PCI_PTM2LA 0xffc00000 /* point to flash */ #define CFG_PCI_PTM2MS 0xffc00001 /* 4MB, enable */ #define CFG_PCI_PTM2PCI 0x04000000 /* Host: use this pci address */ - +#endif /*----------------------------------------------------------------------- * Start addresses for the final memory configuration * (Set up by the startup code) @@ -259,7 +274,7 @@ #define FLASH1_BA 0xFE000000 /* FLASH 1 Base Address */ #define CAN_BA 0xF0000000 /* CAN Base Address */ #define RTC_BA 0xF0000500 /* RTC Base Address */ -#define CF_BA 0xF0100000 /* CompactFlash Base Address */ +#define NVRAM_BA 0xF0200000 /* NVRAM Base Address */ /* Memory Bank 0 (Flash Bank 0) initialization */ #define CFG_EBC_PB0AP 0x92015480 @@ -273,9 +288,11 @@ #define CFG_EBC_PB2AP 0x03000440 /* TWT=5,TH=2,CSN=0,OEN=0,WBN=0,WBF=0 */ #define CFG_EBC_PB2CR CAN_BA | 0x18000 /* BAS=0xF00,BS=1MB,BU=R/W,BW=8bit */ -/* Memory Bank 3 (CompactFlash IDE, FPGA internal) initialization */ -#define CFG_EBC_PB3AP 0x010059C0 /* BWT=2,WBN=1,WBF=1,TH=1,RE=1,SOR=1,BEM=1 */ -#define CFG_EBC_PB3CR CF_BA | 0x1A000 /* BAS=0xF01,BS=1MB,BU=R/W,BW=16bit */ +/* Memory Bank 3 -> unused */ + +/* Memory Bank 4 (NVRAM) initialization */ +#define CFG_EBC_PB4AP 0x03000440 /* TWT=5,TH=2,CSN=0,OEN=0,WBN=0,WBF=0 */ +#define CFG_EBC_PB4CR NVRAM_BA | 0x18000 /* BAS=0xF00,BS=1MB,BU=R/W,BW=8bit */ /*----------------------------------------------------------------------- * FPGA stuff @@ -293,6 +310,15 @@ #define CFG_VXWORKS_MAC_PTR 0x00000000 /* Pass Ethernet MAC to VxWorks */ /*----------------------------------------------------------------------- + * GPIOs + */ +#define CFG_NONMONARCH (0x80000000 >> 14) /* GPIO24 */ +#define CFG_XEREADY (0x80000000 >> 15) /* GPIO15 */ +#define CFG_INTA_FAKE (0x80000000 >> 19) /* GPIO19 */ +#define CFG_SELF_RST (0x80000000 >> 21) /* GPIO21 */ +#define CFG_REV1_2 (0x80000000 >> 23) /* GPIO23 */ + +/*----------------------------------------------------------------------- * Definitions for initial stack pointer and data area (in data cache) */ |