diff options
Diffstat (limited to 'include/configs/MPC8360ERDK.h')
| -rw-r--r-- | include/configs/MPC8360ERDK.h | 88 |
1 files changed, 68 insertions, 20 deletions
diff --git a/include/configs/MPC8360ERDK.h b/include/configs/MPC8360ERDK.h index 27b037a..a4f6af6 100644 --- a/include/configs/MPC8360ERDK.h +++ b/include/configs/MPC8360ERDK.h @@ -30,8 +30,8 @@ * System Clock Setup */ #ifdef CONFIG_CLKIN_33MHZ -#define CONFIG_83XX_CLKIN 33000000 -#define CONFIG_SYS_CLK_FREQ 33000000 +#define CONFIG_83XX_CLKIN 33333333 +#define CONFIG_SYS_CLK_FREQ 33333333 #define PCI_33M 1 #define HRCWL_CSB_TO_CLKIN_MPC8360ERDK HRCWL_CSB_TO_CLKIN_10X1 #else @@ -89,8 +89,8 @@ #define CFG_83XX_DDR_USES_CS0 -#undef CONFIG_DDR_ECC /* support DDR ECC function */ -#undef CONFIG_DDR_ECC_CMD /* Use DDR ECC user commands */ +#define CONFIG_DDR_ECC /* support DDR ECC function */ +#define CONFIG_DDR_ECC_CMD /* Use DDR ECC user commands */ /* * DDRCDR - DDR Control Driver Register @@ -104,20 +104,44 @@ */ #define CONFIG_DDR_II #define CFG_DDR_SIZE 256 /* MB */ -#define CFG_DDRCDR 0x80080001 #define CFG_DDR_CS0_BNDS 0x0000000f #define CFG_DDR_CS0_CONFIG (CSCONFIG_EN | CSCONFIG_ROW_BIT_13 | \ - CSCONFIG_COL_BIT_10) -#define CFG_DDR_TIMING_0 0x00330903 -#define CFG_DDR_TIMING_1 0x3835a322 -#define CFG_DDR_TIMING_2 0x00104909 -#define CFG_DDR_TIMING_3 0x00000000 -#define CFG_DDR_CLK_CNTL 0x02000000 + CSCONFIG_COL_BIT_10 | CSCONFIG_ODT_WR_ACS) +#define CFG_DDR_SDRAM_CFG (SDRAM_CFG_SDRAM_TYPE_DDR2 | SDRAM_CFG_ECC_EN) +#define CFG_DDR_SDRAM_CFG2 0x00001000 +#define CFG_DDR_CLK_CNTL (DDR_SDRAM_CLK_CNTL_CLK_ADJUST_05) +#define CFG_DDR_INTERVAL ((256 << SDRAM_INTERVAL_BSTOPRE_SHIFT) | \ + (1115 << SDRAM_INTERVAL_REFINT_SHIFT)) #define CFG_DDR_MODE 0x47800432 #define CFG_DDR_MODE2 0x8000c000 -#define CFG_DDR_INTERVAL 0x045b0100 -#define CFG_DDR_SDRAM_CFG 0x03000000 -#define CFG_DDR_SDRAM_CFG2 0x00001000 + +#define CFG_DDR_TIMING_0 ((2 << TIMING_CFG0_MRS_CYC_SHIFT) | \ + (9 << TIMING_CFG0_ODT_PD_EXIT_SHIFT) | \ + (3 << TIMING_CFG0_PRE_PD_EXIT_SHIFT) | \ + (3 << TIMING_CFG0_ACT_PD_EXIT_SHIFT) | \ + (0 << TIMING_CFG0_WWT_SHIFT) | \ + (0 << TIMING_CFG0_RRT_SHIFT) | \ + (0 << TIMING_CFG0_WRT_SHIFT) | \ + (0 << TIMING_CFG0_RWT_SHIFT)) + +#define CFG_DDR_TIMING_1 (( TIMING_CFG1_CASLAT_30) | \ + ( 2 << TIMING_CFG1_WRTORD_SHIFT) | \ + ( 2 << TIMING_CFG1_ACTTOACT_SHIFT) | \ + ( 3 << TIMING_CFG1_WRREC_SHIFT) | \ + (10 << TIMING_CFG1_REFREC_SHIFT) | \ + ( 3 << TIMING_CFG1_ACTTORW_SHIFT) | \ + ( 8 << TIMING_CFG1_ACTTOPRE_SHIFT) | \ + ( 3 << TIMING_CFG1_PRETOACT_SHIFT)) + +#define CFG_DDR_TIMING_2 ((9 << TIMING_CFG2_FOUR_ACT_SHIFT) | \ + (4 << TIMING_CFG2_CKE_PLS_SHIFT) | \ + (2 << TIMING_CFG2_WR_DATA_DELAY_SHIFT) | \ + (2 << TIMING_CFG2_RD_TO_PRE_SHIFT) | \ + (2 << TIMING_CFG2_WR_LAT_DELAY_SHIFT) | \ + (0 << TIMING_CFG2_ADD_LAT_SHIFT) | \ + (0 << TIMING_CFG2_CPO_SHIFT)) + +#define CFG_DDR_TIMING_3 0x00000000 /* * Memory test @@ -184,6 +208,11 @@ * NAND flash on the local bus */ #define CFG_NAND_BASE 0x60000000 +#define CONFIG_CMD_NAND 1 +#define CONFIG_NAND_FSL_UPM 1 +#define CFG_MAX_NAND_DEVICE 1 +#define NAND_MAX_CHIPS 1 +#define CONFIG_MTD_NAND_VERIFY_WRITE #define CFG_LBLAWBAR1_PRELIM CFG_NAND_BASE #define CFG_LBLAWAR1_PRELIM 0x8000001b /* Access window size 4K */ @@ -230,6 +259,7 @@ /* Pass open firmware flat tree */ #define CONFIG_OF_LIBFDT 1 #define CONFIG_OF_BOARD_SETUP 1 +#define CONFIG_OF_STDOUT_VIA_ALIAS /* I2C */ #define CONFIG_HARD_I2C /* I2C with hardware support */ @@ -290,7 +320,7 @@ #define CFG_UEC1_TX_CLK QE_CLK9 #define CFG_UEC1_ETH_TYPE GIGA_ETH #define CFG_UEC1_PHY_ADDR 2 -#define CFG_UEC1_INTERFACE_MODE ENET_1000_GMII +#define CFG_UEC1_INTERFACE_MODE ENET_1000_RGMII_RXID #endif #define CONFIG_UEC_ETH2 /* GETH2 */ @@ -301,7 +331,7 @@ #define CFG_UEC2_TX_CLK QE_CLK4 #define CFG_UEC2_ETH_TYPE GIGA_ETH #define CFG_UEC2_PHY_ADDR 4 -#define CFG_UEC2_INTERFACE_MODE ENET_1000_GMII +#define CFG_UEC2_INTERFACE_MODE ENET_1000_RGMII_RXID #endif /* @@ -340,6 +370,7 @@ #define CONFIG_CMD_PING #define CONFIG_CMD_I2C #define CONFIG_CMD_ASKENV +#define CONFIG_CMD_DHCP #if defined(CONFIG_PCI) #define CONFIG_CMD_PCI @@ -499,27 +530,44 @@ "consoledev=ttyS0\0"\ "loadaddr=a00000\0"\ "fdtaddr=900000\0"\ - "bootfile=uImage\0"\ "fdtfile=dtb\0"\ "fsfile=fs\0"\ "ubootfile=u-boot.bin\0"\ + "mtdparts=mtdparts=60000000.nand-flash:4096k(kernel),128k(dtb),-(rootfs)\0"\ "setbootargs=setenv bootargs console=$consoledev,$baudrate "\ "$mtdparts panic=1\0"\ "adddhcpargs=setenv bootargs $bootargs ip=on\0"\ "addnfsargs=setenv bootargs $bootargs ip=$ipaddr:$serverip:"\ "$gatewayip:$netmask:$hostname:$netdev:off "\ "root=/dev/nfs rw nfsroot=$serverip:$rootpath\0"\ + "addnandargs=setenv bootargs $bootargs root=/dev/mtdblock3 "\ + "rootfstype=jffs2 rw\0"\ "tftp_get_uboot=tftp 100000 $ubootfile\0"\ "tftp_get_kernel=tftp $loadaddr $bootfile\0"\ "tftp_get_dtb=tftp $fdtaddr $fdtfile\0"\ "tftp_get_fs=tftp c00000 $fsfile\0"\ + "nand_erase_kernel=nand erase 0 400000\0"\ + "nand_erase_dtb=nand erase 400000 20000\0"\ + "nand_erase_fs=nand erase 420000 3be0000\0"\ + "nand_write_kernel=nand write.jffs2 $loadaddr 0 400000\0"\ + "nand_write_dtb=nand write.jffs2 $fdtaddr 400000 20000\0"\ + "nand_write_fs=nand write.jffs2 c00000 420000 $filesize\0"\ + "nand_read_kernel=nand read.jffs2 $loadaddr 0 400000\0"\ + "nand_read_dtb=nand read.jffs2 $fdtaddr 400000 20000\0"\ "nor_reflash=protect off ff800000 ff87ffff ; erase ff800000 ff87ffff ; "\ "cp.b 100000 ff800000 $filesize\0"\ + "nand_reflash_kernel=run tftp_get_kernel nand_erase_kernel "\ + "nand_write_kernel\0"\ + "nand_reflash_dtb=run tftp_get_dtb nand_erase_dtb nand_write_dtb\0"\ + "nand_reflash_fs=run tftp_get_fs nand_erase_fs nand_write_fs\0"\ + "nand_reflash=run nand_reflash_kernel nand_reflash_dtb "\ + "nand_reflash_fs\0"\ "boot_m=bootm $loadaddr - $fdtaddr\0"\ - "dhcpboot=run setbootargs adddhcpargs tftp_get_kernel tftp_get_dtb "\ - "boot_m\0"\ + "dhcpboot=dhcp ; run setbootargs adddhcpargs tftp_get_dtb boot_m\0"\ "nfsboot=run setbootargs addnfsargs tftp_get_kernel tftp_get_dtb "\ - "boot_m\0"\ + "boot_m\0"\ + "nandboot=run setbootargs addnandargs nand_read_kernel nand_read_dtb "\ + "boot_m\0"\ "" #define CONFIG_BOOTCOMMAND "run dhcpboot" |