diff options
Diffstat (limited to 'drivers/block/systemace.c')
| -rw-r--r-- | drivers/block/systemace.c | 28 |
1 files changed, 14 insertions, 14 deletions
diff --git a/drivers/block/systemace.c b/drivers/block/systemace.c index dfaab52..e8dff0a 100644 --- a/drivers/block/systemace.c +++ b/drivers/block/systemace.c @@ -20,7 +20,7 @@ /* * The Xilinx SystemACE chip support is activated by defining - * CONFIG_SYSTEMACE to turn on support, and CFG_SYSTEMACE_BASE + * CONFIG_SYSTEMACE to turn on support, and CONFIG_SYS_SYSTEMACE_BASE * to set the base address of the device. This code currently * assumes that the chip is connected via a byte-wide bus. * @@ -47,25 +47,25 @@ /* * The ace_readw and writew functions read/write 16bit words, but the * offset value is the BYTE offset as most used in the Xilinx - * datasheet for the SystemACE chip. The CFG_SYSTEMACE_BASE is defined + * datasheet for the SystemACE chip. The CONFIG_SYS_SYSTEMACE_BASE is defined * to be the base address for the chip, usually in the local * peripheral bus. */ -#if (CFG_SYSTEMACE_WIDTH == 8) +#if (CONFIG_SYS_SYSTEMACE_WIDTH == 8) #if !defined(__BIG_ENDIAN) -#define ace_readw(off) ((readb(CFG_SYSTEMACE_BASE+off)<<8) | \ - (readb(CFG_SYSTEMACE_BASE+off+1))) -#define ace_writew(val, off) {writeb(val>>8, CFG_SYSTEMACE_BASE+off); \ - writeb(val, CFG_SYSTEMACE_BASE+off+1);} +#define ace_readw(off) ((readb(CONFIG_SYS_SYSTEMACE_BASE+off)<<8) | \ + (readb(CONFIG_SYS_SYSTEMACE_BASE+off+1))) +#define ace_writew(val, off) {writeb(val>>8, CONFIG_SYS_SYSTEMACE_BASE+off); \ + writeb(val, CONFIG_SYS_SYSTEMACE_BASE+off+1);} #else -#define ace_readw(off) ((readb(CFG_SYSTEMACE_BASE+off)) | \ - (readb(CFG_SYSTEMACE_BASE+off+1)<<8)) -#define ace_writew(val, off) {writeb(val, CFG_SYSTEMACE_BASE+off); \ - writeb(val>>8, CFG_SYSTEMACE_BASE+off+1);} +#define ace_readw(off) ((readb(CONFIG_SYS_SYSTEMACE_BASE+off)) | \ + (readb(CONFIG_SYS_SYSTEMACE_BASE+off+1)<<8)) +#define ace_writew(val, off) {writeb(val, CONFIG_SYS_SYSTEMACE_BASE+off); \ + writeb(val>>8, CONFIG_SYS_SYSTEMACE_BASE+off+1);} #endif #else -#define ace_readw(off) (in16(CFG_SYSTEMACE_BASE+off)) -#define ace_writew(val, off) (out16(CFG_SYSTEMACE_BASE+off,val)) +#define ace_readw(off) (in16(CONFIG_SYS_SYSTEMACE_BASE+off)) +#define ace_writew(val, off) (out16(CONFIG_SYS_SYSTEMACE_BASE+off,val)) #endif /* */ @@ -120,7 +120,7 @@ block_dev_desc_t *systemace_get_dev(int dev) /* * Ensure the correct bus mode (8/16 bits) gets enabled */ - ace_writew(CFG_SYSTEMACE_WIDTH == 8 ? 0 : 0x0001, 0); + ace_writew(CONFIG_SYS_SYSTEMACE_WIDTH == 8 ? 0 : 0x0001, 0); init_part(&systemace_dev); |