diff options
Diffstat (limited to 'cpu/ppc4xx/44x_spd_ddr.c')
| -rw-r--r-- | cpu/ppc4xx/44x_spd_ddr.c | 36 |
1 files changed, 23 insertions, 13 deletions
diff --git a/cpu/ppc4xx/44x_spd_ddr.c b/cpu/ppc4xx/44x_spd_ddr.c index c500d3f..8c18d0f 100644 --- a/cpu/ppc4xx/44x_spd_ddr.c +++ b/cpu/ppc4xx/44x_spd_ddr.c @@ -70,6 +70,15 @@ #define ONE_BILLION 1000000000 +/* + * Board-specific Platform code can reimplement spd_ddr_init_hang () if needed + */ +void __spd_ddr_init_hang (void) +{ + hang (); +} +void spd_ddr_init_hang (void) __attribute__((weak, alias("__spd_ddr_init_hang"))); + /*----------------------------------------------------------------------------- | Memory Controller Options 0 +-----------------------------------------------------------------------------*/ @@ -262,7 +271,7 @@ typedef struct bank_param BANKPARMS; #ifdef CFG_SIMULATE_SPD_EEPROM extern unsigned char cfg_simulate_spd_eeprom[128]; #endif -void program_tlb(u32 start, u32 size, u32 tlb_word2_i_value); +void program_tlb(u32 phys_addr, u32 virt_addr, u32 size, u32 tlb_word2_i_value); static unsigned char spd_read(uchar chip, uint addr); static void get_spd_info(unsigned long *dimm_populated, @@ -373,7 +382,7 @@ long int spd_sdram(void) { #ifdef CONFIG_PROG_SDRAM_TLB /* this define should eventually be removed */ /* and program tlb entries for this size (dynamic) */ - program_tlb(0, total_size, MY_TLB_WORD2_I_ENABLE); + program_tlb(0, 0, total_size, MY_TLB_WORD2_I_ENABLE); #endif /* @@ -467,7 +476,7 @@ static void get_spd_info(unsigned long *dimm_populated, if (dimm_found == FALSE) { printf("ERROR - No memory installed. Install a DDR-SDRAM DIMM.\n\n"); - hang(); + spd_ddr_init_hang (); } } @@ -490,7 +499,7 @@ static void check_mem_type(unsigned long *dimm_populated, dimm_num); printf("Only DDR SDRAM DIMMs are supported.\n"); printf("Replace the DIMM module with a supported DIMM.\n\n"); - hang(); + spd_ddr_init_hang (); break; } } @@ -510,7 +519,7 @@ static void check_volt_type(unsigned long *dimm_populated, if (voltage_type != 0x04) { printf("ERROR: DIMM %lu with unsupported voltage level.\n", dimm_num); - hang(); + spd_ddr_init_hang (); } else { debug("DIMM %lu voltage level supported.\n", dimm_num); } @@ -581,7 +590,7 @@ static void program_cfg0(unsigned long *dimm_populated, printf("WARNING: DIMM with datawidth of %lu bits.\n", data_width); printf("Only DIMMs with 32 or 64 bit datawidths supported.\n"); - hang(); + spd_ddr_init_hang (); } break; } @@ -769,7 +778,7 @@ static void program_tr0(unsigned long *dimm_populated, if ((tcyc_reg & 0x0F) >= 10) { printf("ERROR: Tcyc incorrect for DIMM in slot %lu\n", dimm_num); - hang(); + spd_ddr_init_hang (); } cycle_time_ns_x_10[cas_index] = @@ -849,7 +858,7 @@ static void program_tr0(unsigned long *dimm_populated, printf("ERROR: No supported CAS latency with the installed DIMMs.\n"); printf("Only CAS latencies of 2.0, 2.5, and 3.0 are supported.\n"); printf("Make sure the PLB speed is within the supported range.\n"); - hang(); + spd_ddr_init_hang (); } /* @@ -1008,6 +1017,7 @@ static int short_mem_test(void) */ for (i = 0; i < NUMMEMTESTS; i++) { for (j = 0; j < NUMMEMWORDS; j++) { +//printf("bank enabled base:%x\n", &membase[j]); membase[j] = test[i][j]; ppcDcbf((unsigned long)&(membase[j])); } @@ -1160,7 +1170,7 @@ static void program_tr1(void) */ if (window_found == FALSE) { printf("ERROR: Cannot determine a common read delay.\n"); - hang(); + spd_ddr_init_hang (); } /* @@ -1310,7 +1320,7 @@ static unsigned long program_bxcr(unsigned long *dimm_populated, printf("ERROR: Unsupported value for the banksize: %d.\n", bank_size_id); printf("Replace the DIMM module with a supported DIMM.\n\n"); - hang(); + spd_ddr_init_hang (); } switch (num_col_addr) { @@ -1332,7 +1342,7 @@ static unsigned long program_bxcr(unsigned long *dimm_populated, printf("ERROR: Unsupported value for number of " "column addresses: %d.\n", num_col_addr); printf("Replace the DIMM module with a supported DIMM.\n\n"); - hang(); + spd_ddr_init_hang (); } /* @@ -1340,14 +1350,14 @@ static unsigned long program_bxcr(unsigned long *dimm_populated, */ cr |= SDRAM_BXCR_SDBE; - for (i = 0; i < num_banks; i++) { + for (i = 0; i < num_banks; i++) { bank_parms[ctrl_bank_num[dimm_num]+i].bank_size_bytes = (4 << 20) * bank_size_id; bank_parms[ctrl_bank_num[dimm_num]+i].cr = cr; debug("DIMM%d-bank %d (SDRAM0_B%dCR): bank_size_bytes=%d\n", dimm_num, i, ctrl_bank_num[dimm_num]+i, bank_parms[ctrl_bank_num[dimm_num]+i].bank_size_bytes); - } + } } } |