diff options
Diffstat (limited to 'board/ti')
| -rw-r--r-- | board/ti/k2hk_evm/README | 28 |
1 files changed, 27 insertions, 1 deletions
diff --git a/board/ti/k2hk_evm/README b/board/ti/k2hk_evm/README index bfeb05b..7426b8d 100644 --- a/board/ti/k2hk_evm/README +++ b/board/ti/k2hk_evm/README @@ -38,11 +38,13 @@ board configuration file: include/configs/k2hk_evm.h Supported boot modes: - SPI NOR boot + - AEMIF NAND boot Supported image formats:- - u-boot.bin: for loading and running u-boot.bin through Texas instruments code composure studio (CCS) - u-boot-spi.gph: gpimage for programming SPI NOR flash for SPI NOR boot + - u-boot-nand.gph: gpimage for programming AEMIF NAND flash for NAND boot Build instructions: =================== @@ -55,6 +57,10 @@ To build u-boot-spi.gph >make k2hk_evm_config >make u-boot-spi.gph +To build u-boot-nand.gph + >make k2hk_evm_config + >make u-boot-nand.gph + Load and Run U-Boot on K2HK EVM using CCS ========================================= @@ -115,8 +121,28 @@ instructions:- 5. At the U-Boot console type following to setup u-boot environment variables. setenv addr_uboot 0x87000000 setenv filesize <size in hex of u-boot-spi.gph rounded to hex 0x10000> - run burn_uboot + run burn_uboot_spi Once u-boot prompt is available, Power OFF the EVM. Set the SW1 dip switch to "SPI Little Endian Boot mode" as per instruction at http://processors.wiki.ti.com/index.php/EVMK2H_Hardware_Setup. 6. Power ON the EVM. The EVM now boots with u-boot image on the NOR flash. + +AEMIF NAND Flash programming instructions +====================================== +U-Boot image can be flashed to first 1024KB of the NAND flash using following +instructions:- + +1. Start CCS and run U-boot as described above. +2. Suspend Target. Select Run -> Suspend from top level menu + CortexA15_1 (Free Running)" +3. Load u-boot-nand.gph binary from build folder on to DDR address 0x87000000 + through CCS as described in step 2 of "Load and Run U-Boot on K2HK EVM + using CCS", but using address 0x87000000. +4. Free Run the target as desribed earlier (step 4) to get u-boot prompt +5. At the U-Boot console type following to setup u-boot environment variables. + setenv filesize <size in hex of u-boot-nand.gph rounded to hex 0x10000> + run burn_uboot_nand + Once u-boot prompt is available, Power OFF the EVM. Set the SW1 dip switch + to "ARM NAND Boot mode" as per instruction at + http://processors.wiki.ti.com/index.php/EVMK2H_Hardware_Setup. +6. Power ON the EVM. The EVM now boots with u-boot image on the NAND flash. |