1 files changed, 30 insertions, 0 deletions
diff --git a/board/rpxsuper/readme b/board/rpxsuper/readme
new file mode 100644
index 0000000..21267bd
--- /dev/null
+++ b/board/rpxsuper/readme
@@ -0,0 +1,30 @@
+Hi,
+
+so this is the port to the Embedded Planet RPX Super Board.
+
+ATTENTION
+This code is only tested on the AY-Version, which is an early release with some
+hardware bugs. The main problem is that this board uses the default Hard Reset
+Configuration Word and not the 4 bytes located at start of FLASH because at
+0xFE000000 is no FLASH. The FLASH consists out of 4 chips each 16bits wide. Be
+carefull, the bytes are swapped. So DQ0-7 is the high byte, DQ8-15 ist the low
+byte.
+
+The icache can only manually be enabled after reset.
+The FLASH and main SDRAM is working with icache enabled.
+The local SDRAM can only be used as data memory when icache is enabled.
+If U-Boot runs in local SDRAM, TFTP does not work.
+The functions in mii_phy.c are all working. Call mii_phy_discover() out of
+eth_init() and solve the linker error.
+I2C, RTC/NVRAM and PCMCIA are not working yet.
+
+TODO
+The 32MB local SDRAM is working but not shown in the startup messages of
+U-Boot. If you locate U-Boot or any other program to this area it won't run.
+Turning the ichache off does not solve this problem.
+
+As I won't buy another RPX Super there might be some little work to do for you
+getting this U-Boot port running on the final board.
+
+
+frank.morauf@salzbrenner.com