diff options
Diffstat (limited to 'board/musenki/README')
| -rw-r--r-- | board/musenki/README | 298 |
1 files changed, 0 insertions, 298 deletions
diff --git a/board/musenki/README b/board/musenki/README deleted file mode 100644 index 084ab54..0000000 --- a/board/musenki/README +++ /dev/null @@ -1,298 +0,0 @@ -U-Boot for a Musenki M-3/M-1 board ---------------------------- - -Musenki M-1 and M-3 have two banks of flash of 4MB or 8MB each. - -In board's notation, bank 0 is the one at the address of 0xFF800000 -and bank 1 is the one at the address of 0xFF000000. - -On power-up the processor jumps to the address of 0xFFF00100, the last -megabyte of the bank 0 of flash. - -Thus, U-Boot is configured to reside in flash starting at the address of -0xFFF00000. The environment space is located in flash separately from -U-Boot, at the address of 0xFF800000. - -There is a Davicom 9102A on-board, but I don't have it working yet. - -U-Boot test results --------------------- - -x.x Operation on all available serial consoles - -x.x.x CONFIG_CONS_INDEX 1 - - -U-Boot 1.1.1 (Nov 20 2001 - 15:55:32) - -CPU: MPC8245 Revision 16.20 at 250 MHz: 16 kB I-Cache 16 kB D-Cache -Board: MUSENKI Local Bus at 100 MHz -DRAM: 32 MB -FLASH: 4 MB -In: serial -Out: serial -Err: serial -Hit any key to stop autoboot: 0 -=> help -base - print or set address offset -bdinfo - print Board Info structure -bootm - boot application image from memory -bootp - boot image via network using BootP/TFTP protocol -bootd - boot default, i.e., run 'bootcmd' -cmp - memory compare -coninfo - print console devices and informations -cp - memory copy -crc32 - checksum calculation -dcache - enable or disable data cache -echo - echo args to console -erase - erase FLASH memory -flinfo - print FLASH memory information -go - start application at address 'addr' -help - print online help -icache - enable or disable instruction cache -iminfo - print header information for application image -loadb - load binary file over serial line (kermit mode) -loads - load S-Record file over serial line -loop - infinite loop on address range -md - memory display -mm - memory modify (auto-incrementing) -mtest - simple RAM test -mw - memory write (fill) -nm - memory modify (constant address) -printenv- print environment variables -protect - enable or disable FLASH write protection -rarpboot- boot image via network using RARP/TFTP protocol -reset - Perform RESET of the CPU -run - run commands in an environment variable -saveenv - save environment variables to persistent storage -setenv - set environment variables -source - run script from memory -tftpboot- boot image via network using TFTP protocol - and env variables ipaddr and serverip -version - print monitor version -? - alias for 'help' - - -x.x.x CONFIG_CONS_INDEX 2 - -**** NOT TESTED **** - -x.x Flash Driver Operation - - -Boot 1.1.1 (Nov 20 2001 - 15:55:32) - -CPU: MPC8245 Revision 16.20 at 250 MHz: 16 kB I-Cache 16 kB D-Cache -Board: MUSENKI Local Bus at 100 MHz -DRAM: 32 MB -FLASH: 4 MB -*** Warning - bad CRC, using default environment - -In: serial -Out: serial -Err: serial -Hit any key to stop autoboot: 0 -=> -=> md ff800000 -ff800000: 46989bf8 626f6f74 636d643d 626f6f74 F...bootcmd=boot -ff800010: 6d204646 38323030 30300062 6f6f7464 m FF820000.bootd -ff800020: 656c6179 3d350062 61756472 6174653d elay=5.baudrate= -ff800030: 39363030 00636c6f 636b735f 696e5f6d 9600.clocks_in_m -ff800040: 687a3d31 00737464 696e3d73 65726961 hz=1.stdin=seria -ff800050: 6c007374 646f7574 3d736572 69616c00 l.stdout=serial. -ff800060: 73746465 72723d73 65726961 6c006970 stderr=serial.ip -ff800070: 61646472 3d313932 2e313638 2e302e34 addr=192.168.0.4 -ff800080: 32007365 72766572 69703d31 39322e31 2.serverip=192.1 -ff800090: 36382e30 2e380000 00000000 00000000 68.0.8.......... -ff8000a0: 00000000 00000000 00000000 00000000 ................ -ff8000b0: 00000000 00000000 00000000 00000000 ................ -ff8000c0: 00000000 00000000 00000000 00000000 ................ -ff8000d0: 00000000 00000000 00000000 00000000 ................ -ff8000e0: 00000000 00000000 00000000 00000000 ................ -ff8000f0: 00000000 00000000 00000000 00000000 ................ -=> protect off ff800000 ff81ffff -Un-Protected 1 sectors -=> erase ff800000 ff81ffff -Erase Flash from 0xff800000 to 0xff81ffff - done -Erased 1 sectors -=> md ff800000 -ff800000: ffffffff ffffffff ffffffff ffffffff ................ -ff800010: ffffffff ffffffff ffffffff ffffffff ................ -ff800020: ffffffff ffffffff ffffffff ffffffff ................ -ff800030: ffffffff ffffffff ffffffff ffffffff ................ -ff800040: ffffffff ffffffff ffffffff ffffffff ................ -ff800050: ffffffff ffffffff ffffffff ffffffff ................ -ff800060: ffffffff ffffffff ffffffff ffffffff ................ -ff800070: ffffffff ffffffff ffffffff ffffffff ................ -ff800080: ffffffff ffffffff ffffffff ffffffff ................ -ff800090: ffffffff ffffffff ffffffff ffffffff ................ -ff8000a0: ffffffff ffffffff ffffffff ffffffff ................ -ff8000b0: ffffffff ffffffff ffffffff ffffffff ................ -ff8000c0: ffffffff ffffffff ffffffff ffffffff ................ -ff8000d0: ffffffff ffffffff ffffffff ffffffff ................ -ff8000e0: ffffffff ffffffff ffffffff ffffffff ................ -ff8000f0: ffffffff ffffffff ffffffff ffffffff ................ - -x.x.x Information - - -U-Boot 1.1.1 (Nov 20 2001 - 15:55:32) - -CPU: MPC8245 Revision 16.20 at 250 MHz: 16 kB I-Cache 16 kB D-Cache -Board: MUSENKI Local Bus at 100 MHz -DRAM: 32 MB -FLASH: 4 MB -*** Warning - bad CRC, using default environment - -In: serial -Out: serial -Err: serial -Hit any key to stop autoboot: 0 -=> flinfo - -Bank # 1: Intel 28F320J3A (32Mbit = 128K x 32) - Size: 4 MB in 32 Sectors - Sector Start Addresses: - FF800000 (RO) FF820000 FF840000 FF860000 FF880000 - FF8A0000 FF8C0000 FF8E0000 FF900000 FF920000 - FF940000 FF960000 FF980000 FF9A0000 FF9C0000 - FF9E0000 FFA00000 FFA20000 FFA40000 FFA60000 - FFA80000 FFAA0000 FFAC0000 FFAE0000 FFB00000 - FFB20000 FFB40000 FFB60000 FFB80000 FFBA0000 - FFBC0000 FFBE0000 - -Bank # 2: missing or unknown FLASH type -=> - - -x.x.x Flash Programming - - -U-Boot 1.1.1 (Nov 20 2001 - 15:55:32) - -CPU: MPC8245 Revision 16.20 at 250 MHz: 16 kB I-Cache 16 kB D-Cache -Board: MUSENKI Local Bus at 100 MHz -DRAM: 32 MB -FLASH: 4 MB - -In: serial -Out: serial -Err: serial -Hit any key to stop autoboot: 0 -=> -=> -=> -=> protect off ff800000 ff81ffff -Un-Protected 1 sectors -=> cp 0 ff800000 20 -Copy to Flash... done -=> md ff800000 -ff800000: 37ce33ec 33cc334c 33c031cc 33cc35cc 7.3.3.3L3.1.3.5. -ff800010: 33ec13ce 30ccb3ec b3c833c4 31c836cc 3...0.....3.1.6. -ff800020: 33cc3b9d 31ec33ee 13ecf3cc 338833ec 3.;.1.3.....3.3. -ff800030: 234c33ec 32cc22cc 33883bdc 534433cc #L3.2.".3.;.SD3. -ff800040: 33cc30c8 31cc32ec 338c33cc 330c33dc 3.0.1.2.3.3.3.3. -ff800050: 33cc13dc 334c534c b1c433d8 128c13cc 3...3LSL..3..... -ff800060: 37ec36cd 33dc33cc bbc9f7e8 bbcc77cc 7.6.3.3.......w. -ff800070: 314c0adc 139c30ed 33cc334c 33c833ec 1L....0.3.3L3.3. -ff800080: ffffffff ffffffff ffffffff ffffffff ................ -ff800090: ffffffff ffffffff ffffffff ffffffff ................ -ff8000a0: ffffffff ffffffff ffffffff ffffffff ................ -ff8000b0: ffffffff ffffffff ffffffff ffffffff ................ -ff8000c0: ffffffff ffffffff ffffffff ffffffff ................ -ff8000d0: ffffffff ffffffff ffffffff ffffffff ................ -ff8000e0: ffffffff ffffffff ffffffff ffffffff ................ -ff8000f0: ffffffff ffffffff ffffffff ffffffff ................ - - -x.x.x Storage of environment variables in flash - - -U-Boot 1.1.1 (Nov 20 2001 - 15:55:32) - -CPU: MPC8245 Revision 16.20 at 250 MHz: 16 kB I-Cache 16 kB D-Cache -Board: MUSENKI Local Bus at 100 MHz -DRAM: 32 MB -FLASH: 4 MB -In: serial -Out: serial -Err: serial -Hit any key to stop autoboot: 0 -=> printenv -bootcmd=bootm FF820000 -bootdelay=5 -baudrate=9600 -clocks_in_mhz=1 -stdin=serial -stdout=serial -stderr=serial - -Environment size: 106/16380 bytes -=> setenv myvar 1234 -=> saveenv -Un-Protected 1 sectors -Erasing Flash... - done -Erased 1 sectors -Saving Environment to Flash... -Protected 1 sectors -=> reset - - -U-Boot 1.1.1 (Nov 20 2001 - 15:55:32) - -CPU: MPC8245 Revision 16.20 at 250 MHz: 16 kB I-Cache 16 kB D-Cache -Board: MUSENKI Local Bus at 100 MHz -DRAM: 32 MB -FLASH: 4 MB -In: serial -Out: serial -Err: serial -Hit any key to stop autoboot: 0 -=> printenv -bootcmd=bootm FF820000 -bootdelay=5 -baudrate=9600 -clocks_in_mhz=1 -myvar=1234 -stdin=serial -stdout=serial -stderr=serial - -Environment size: 117/16380 bytes - -x.x Image Download and run over serial port - - -U-Boot 1.1.1 (Nov 20 2001 - 15:55:32) - -CPU: MPC8245 Revision 16.20 at 250 MHz: 16 kB I-Cache 16 kB D-Cache -Board: MUSENKI Local Bus at 100 MHz -DRAM: 32 MB -FLASH: 4 MB -In: serial -Out: serial -Err: serial -Hit any key to stop autoboot: 0 -=> loads -## Ready for S-Record download ... - -## First Load Addr = 0x00040000 -## Last Load Addr = 0x00050177 -## Total Size = 0x00010178 = 65912 Bytes -## Start Addr = 0x00040004 -=> go 40004 -## Starting application at 0x00040004 ... -Hello World -argc = 1 -argv[0] = "40004" -argv[1] = "<NULL>" -Hit any key to exit ... - -## Application terminated, rc = 0x0 - - -x.x Image download and run over ethernet interface - -untested (not working yet, actually) |