diff options
Diffstat (limited to 'board/freescale/t104xrdb')
| -rw-r--r-- | board/freescale/t104xrdb/MAINTAINERS | 1 | ||||
| -rw-r--r-- | board/freescale/t104xrdb/README | 23 | ||||
| -rw-r--r-- | board/freescale/t104xrdb/ddr.c | 4 | ||||
| -rw-r--r-- | board/freescale/t104xrdb/eth.c | 10 | ||||
| -rw-r--r-- | board/freescale/t104xrdb/t1042_pi_rcw.cfg | 7 | ||||
| -rw-r--r-- | board/freescale/t104xrdb/t1042_rcw.cfg | 8 |
6 files changed, 42 insertions, 11 deletions
diff --git a/board/freescale/t104xrdb/MAINTAINERS b/board/freescale/t104xrdb/MAINTAINERS index a4775c0..b61e1c0 100644 --- a/board/freescale/t104xrdb/MAINTAINERS +++ b/board/freescale/t104xrdb/MAINTAINERS @@ -6,6 +6,7 @@ F: include/configs/T104xRDB.h F: configs/T1040RDB_defconfig F: configs/T1040RDB_NAND_defconfig F: configs/T1040RDB_SPIFLASH_defconfig +F: configs/T1042RDB_defconfig F: configs/T1042RDB_PI_defconfig F: configs/T1042RDB_PI_NAND_defconfig F: configs/T1042RDB_PI_SPIFLASH_defconfig diff --git a/board/freescale/t104xrdb/README b/board/freescale/t104xrdb/README index cdbe1fa..ac95b5e 100644 --- a/board/freescale/t104xrdb/README +++ b/board/freescale/t104xrdb/README @@ -4,10 +4,23 @@ The T1040RDB is a Freescale reference board that hosts the T1040 SoC (and variants). Variants inclued T1042 presonality of T1040, in which case T1040RDB can also be called T1042RDB. +The T1042RDB is a Freescale reference board that hosts the T1042 SoC +(and variants). The board is similar to T1040RDB, T1040 is a reduced +personality of T1040 SoC without Integrated 8-port Gigabit(L2 Switch). + The T1042RDB_PI is a Freescale reference board that hosts the T1042 SoC. (a personality of T1040 SoC). The board is similar to T1040RDB but is designed specially with low power features targeted for Printing Image Market. +Basic difference's among T1040RDB, T1042RDB_PI, T1042RDB +------------------------------------------------------------------------- +Board Si Protocol Targeted Market +------------------------------------------------------------------------- +T1040RDB T1040 0x66 Networking +T1040RDB T1042 0x86 Networking +T1042RDB_PI T1042 0x06 Printing & Imaging + + T1040 SoC Overview ------------------ The QorIQ T1040/T1042 processor support four integrated 64-bit e5500 PA @@ -194,10 +207,10 @@ The below commands apply to the board Commands for switching to alternate bank. 1. To change from vbank0 to vbank4 - => qixis_reset altbank (it will boot using vbank4) + => cpld reset altbank (it will boot using vbank4) 2.To change from vbank4 to vbank0 - => qixis reset (it will boot using vbank0) + => cpld reset (it will boot using vbank0) NAND boot with 2 Stage boot loader ---------------------------------- @@ -259,15 +272,15 @@ Switch Settings: (ON is 0, OFF is 1) =============== NAND boot SW setting: SW1: 10001000 -SW2: 00111001 +SW2: 00111011 SW3: 11110001 SPI boot SW setting: SW1: 00100010 -SW2: 10111001 +SW2: 10111011 SW3: 11100001 SD boot SW setting: SW1: 00100000 -SW2: 00111001 +SW2: 00111011 SW3: 11100001 diff --git a/board/freescale/t104xrdb/ddr.c b/board/freescale/t104xrdb/ddr.c index 34c9224..2c331ee 100644 --- a/board/freescale/t104xrdb/ddr.c +++ b/board/freescale/t104xrdb/ddr.c @@ -105,8 +105,8 @@ found: popts->zq_en = 1; /* DHC_EN =1, ODT = 75 Ohm */ - popts->ddr_cdr1 = DDR_CDR1_DHC_EN | DDR_CDR1_ODT(DDR_CDR_ODT_OFF); - popts->ddr_cdr2 = DDR_CDR2_ODT(DDR_CDR_ODT_OFF); + popts->ddr_cdr1 = DDR_CDR1_DHC_EN | DDR_CDR1_ODT(DDR_CDR_ODT_75ohm); + popts->ddr_cdr2 = DDR_CDR2_ODT(DDR_CDR_ODT_75ohm); } phys_size_t initdram(int board_type) diff --git a/board/freescale/t104xrdb/eth.c b/board/freescale/t104xrdb/eth.c index 63e5f90..c8b6c67 100644 --- a/board/freescale/t104xrdb/eth.c +++ b/board/freescale/t104xrdb/eth.c @@ -43,6 +43,16 @@ int board_eth_init(bd_t *bis) CONFIG_SYS_SGMII1_PHY_ADDR); break; #endif +#ifdef CONFIG_T1042RDB + case PHY_INTERFACE_MODE_SGMII: + /* T1042RDB doesn't supports SGMII on DTSEC1 & DTSEC2 */ + if ((FM1_DTSEC1 == i) || (FM1_DTSEC2 == i)) + fm_info_set_phy_address(i, 0); + /* T1042RDB only supports SGMII on DTSEC3 */ + fm_info_set_phy_address(FM1_DTSEC3, + CONFIG_SYS_SGMII1_PHY_ADDR); + break; +#endif case PHY_INTERFACE_MODE_RGMII: if (FM1_DTSEC4 == i) phy_addr = CONFIG_SYS_RGMII1_PHY_ADDR; diff --git a/board/freescale/t104xrdb/t1042_pi_rcw.cfg b/board/freescale/t104xrdb/t1042_pi_rcw.cfg new file mode 100644 index 0000000..57de89a --- /dev/null +++ b/board/freescale/t104xrdb/t1042_pi_rcw.cfg @@ -0,0 +1,7 @@ +#PBL preamble and RCW header +aa55aa55 010e0100 +# serdes protocol 0x06 +0c18000e 0e000000 00000000 00000000 +06000002 00400002 e8106000 01000000 +00000000 00000000 00000000 00030810 +00000000 01fe0a06 00000000 00000000 diff --git a/board/freescale/t104xrdb/t1042_rcw.cfg b/board/freescale/t104xrdb/t1042_rcw.cfg index a3ea8ad..db4d52f 100644 --- a/board/freescale/t104xrdb/t1042_rcw.cfg +++ b/board/freescale/t104xrdb/t1042_rcw.cfg @@ -1,7 +1,7 @@ #PBL preamble and RCW header aa55aa55 010e0100 -# serdes protocol 0x66 +# serdes protocol 0x86 0c18000e 0e000000 00000000 00000000 -06000002 00400002 e8106000 01000000 -00000000 00000000 00000000 00030810 -00000000 01fe0a06 00000000 00000000 +86000002 80000002 ec027000 01000000 +00000000 00000000 00000000 00032810 +00000000 0342500f 00000000 00000000 |