diff options
Diffstat (limited to 'arch/arm/cpu/ixp')
| -rw-r--r-- | arch/arm/cpu/ixp/start.S | 203 |
1 files changed, 0 insertions, 203 deletions
diff --git a/arch/arm/cpu/ixp/start.S b/arch/arm/cpu/ixp/start.S index a2560d4..0269207 100644 --- a/arch/arm/cpu/ixp/start.S +++ b/arch/arm/cpu/ixp/start.S @@ -98,12 +98,6 @@ _fiq: .word fiq _TEXT_BASE: .word CONFIG_SYS_TEXT_BASE -#if defined(CONFIG_SYS_ARM_WITHOUT_RELOC) -.globl _armboot_start -_armboot_start: - .word _start -#endif - /* * These are defined in the board-specific linker script. */ @@ -127,7 +121,6 @@ FIQ_STACK_START: .word 0x0badc0de #endif -#if !defined(CONFIG_SYS_ARM_WITHOUT_RELOC) /* IRQ stack memory (calculated at run-time) + 8 bytes */ .globl IRQ_STACK_START_IN IRQ_STACK_START_IN: @@ -394,190 +387,6 @@ clbss_l:str r2, [r0] /* clear loop... */ _board_init_r: .word board_init_r -#else /* #if !defined(CONFIG_SYS_ARM_WITHOUT_RELOC) */ -/****************************************************************************/ -/* */ -/* the actual reset code */ -/* */ -/****************************************************************************/ - -reset: - /* disable mmu, set big-endian */ - mov r0, #0xf8 - mcr p15, 0, r0, c1, c0, 0 - CPWAIT r0 - - /* invalidate I & D caches & BTB */ - mcr p15, 0, r0, c7, c7, 0 - CPWAIT r0 - - /* invalidate I & Data TLB */ - mcr p15, 0, r0, c8, c7, 0 - CPWAIT r0 - - /* drain write and fill buffers */ - mcr p15, 0, r0, c7, c10, 4 - CPWAIT r0 - - /* disable write buffer coalescing */ - mrc p15, 0, r0, c1, c0, 1 - orr r0, r0, #1 - mcr p15, 0, r0, c1, c0, 1 - CPWAIT r0 - - /* set EXP CS0 to the optimum timing */ - ldr r1, =CONFIG_SYS_EXP_CS0 - ldr r2, =IXP425_EXP_CS0 - str r1, [r2] - - /* make sure flash is visible at 0 */ -#if 0 - ldr r2, =IXP425_EXP_CFG0 - ldr r1, [r2] - orr r1, r1, #0x80000000 - str r1, [r2] -#endif - mov r1, #CONFIG_SYS_SDR_CONFIG - ldr r2, =IXP425_SDR_CONFIG - str r1, [r2] - - /* disable refresh cycles */ - mov r1, #0 - ldr r3, =IXP425_SDR_REFRESH - str r1, [r3] - - /* send nop command */ - mov r1, #3 - ldr r4, =IXP425_SDR_IR - str r1, [r4] - DELAY_FOR 0x4000, r0 - - /* set SDRAM internal refresh val */ - ldr r1, =CONFIG_SYS_SDRAM_REFRESH_CNT - str r1, [r3] - DELAY_FOR 0x4000, r0 - - /* send precharge-all command to close all open banks */ - mov r1, #2 - str r1, [r4] - DELAY_FOR 0x4000, r0 - - /* provide 8 auto-refresh cycles */ - mov r1, #4 - mov r5, #8 -111: str r1, [r4] - DELAY_FOR 0x100, r0 - subs r5, r5, #1 - bne 111b - - /* set mode register in sdram */ - mov r1, #CONFIG_SYS_SDR_MODE_CONFIG - str r1, [r4] - DELAY_FOR 0x4000, r0 - - /* send normal operation command */ - mov r1, #6 - str r1, [r4] - DELAY_FOR 0x4000, r0 - - /* copy */ - mov r0, #0 - mov r4, r0 - add r2, r0, #CONFIG_SYS_MONITOR_LEN - mov r1, #0x10000000 - mov r5, r1 - - 30: - ldr r3, [r0], #4 - str r3, [r1], #4 - cmp r0, r2 - bne 30b - - /* invalidate I & D caches & BTB */ - mcr p15, 0, r0, c7, c7, 0 - CPWAIT r0 - - /* invalidate I & Data TLB */ - mcr p15, 0, r0, c8, c7, 0 - CPWAIT r0 - - /* drain write and fill buffers */ - mcr p15, 0, r0, c7, c10, 4 - CPWAIT r0 - - /* move flash to 0x50000000 */ - ldr r2, =IXP425_EXP_CFG0 - ldr r1, [r2] - bic r1, r1, #0x80000000 - str r1, [r2] - - nop - nop - nop - nop - nop - nop - - /* invalidate I & Data TLB */ - mcr p15, 0, r0, c8, c7, 0 - CPWAIT r0 - - /* enable I cache */ - mrc p15, 0, r0, c1, c0, 0 - orr r0, r0, #MMU_Control_I - mcr p15, 0, r0, c1, c0, 0 - CPWAIT r0 - - mrs r0,cpsr /* set the cpu to SVC32 mode */ - bic r0,r0,#0x1f /* (superviser mode, M=10011) */ - orr r0,r0,#0x13 - msr cpsr,r0 - -#ifndef CONFIG_SKIP_RELOCATE_UBOOT -relocate: /* relocate U-Boot to RAM */ - adr r0, _start /* r0 <- current position of code */ - ldr r1, _TEXT_BASE /* test if we run from flash or RAM */ - cmp r0, r1 /* don't reloc during debug */ - beq stack_setup - - ldr r2, _armboot_start - ldr r3, _bss_start - sub r2, r3, r2 /* r2 <- size of armboot */ - add r2, r0, r2 /* r2 <- source end address */ - -copy_loop: - ldmia r0!, {r3-r10} /* copy from source address [r0] */ - stmia r1!, {r3-r10} /* copy to target address [r1] */ - cmp r0, r2 /* until source end address [r2] */ - blo copy_loop -#endif /* CONFIG_SKIP_RELOCATE_UBOOT */ - - /* Set up the stack */ -stack_setup: - ldr r0, _TEXT_BASE /* upper 128 KiB: relocated uboot */ - sub r0, r0, #CONFIG_SYS_MALLOC_LEN /* malloc area */ - sub r0, r0, #GENERATED_GBL_DATA_SIZE /* bdinfo */ -#ifdef CONFIG_USE_IRQ - sub r0, r0, #(CONFIG_STACKSIZE_IRQ+CONFIG_STACKSIZE_FIQ) -#endif - sub sp, r0, #12 /* leave 3 words for abort-stack */ - bic sp, sp, #7 /* 8-byte alignment for ABI compliance */ - -clear_bss: - ldr r0, _bss_start /* find start of bss segment */ - ldr r1, _bss_end /* stop here */ - mov r2, #0x00000000 /* clear */ - -clbss_l:str r2, [r0] /* clear loop... */ - add r0, r0, #4 - cmp r0, r1 - blo clbss_l - - ldr pc, _start_armboot - -_start_armboot: .word start_armboot -#endif /* #if !defined(CONFIG_SYS_ARM_WITHOUT_RELOC) */ - /****************************************************************************/ /* */ @@ -618,13 +427,7 @@ _start_armboot: .word start_armboot stmia sp, {r0 - r12} /* Calling r0-r12 */ add r8, sp, #S_PC -#if defined(CONFIG_SYS_ARM_WITHOUT_RELOC) - ldr r2, _armboot_start - sub r2, r2, #(CONFIG_STACKSIZE+CONFIG_SYS_MALLOC_LEN) - sub r2, r2, #(GENERATED_GBL_DATA_SIZE+8) @ set base 2 words into abort stack -#else ldr r2, IRQ_STACK_START_IN -#endif ldmia r2, {r2 - r4} /* get pc, cpsr, old_r0 */ add r0, sp, #S_FRAME_SIZE /* restore sp_SVC */ @@ -659,13 +462,7 @@ _start_armboot: .word start_armboot .endm .macro get_bad_stack -#if defined(CONFIG_SYS_ARM_WITHOUT_RELOC) - ldr r13, _armboot_start @ setup our mode stack - sub r13, r13, #(CONFIG_STACKSIZE+CONFIG_SYS_MALLOC_LEN) - sub r13, r13, #(GENERATED_GBL_DATA_SIZE+8) @ reserved a couple spots in abort stack -#else ldr r13, IRQ_STACK_START_IN @ setup our mode stack -#endif str lr, [r13] @ save caller lr / spsr mrs lr, spsr |