diff options
Diffstat (limited to 'README')
| -rw-r--r-- | README | 38 |
1 files changed, 38 insertions, 0 deletions
@@ -751,6 +751,9 @@ The following options need to be configured: CONFIG_E1000 Support for Intel 8254x gigabit chips. + CONFIG_E1000_FALLBACK_MAC + default MAC for empty eeprom after production. + CONFIG_EEPRO100 Support for Intel 82557/82559/82559ER chips. Optional CONFIG_EEPRO100_SROM_WRITE enables eeprom @@ -1151,6 +1154,20 @@ The following options need to be configured: of the "hostname" environment variable is passed as option 12 to the DHCP server. + CONFIG_BOOTP_DHCP_REQUEST_DELAY + + A 32bit value in microseconds for a delay between + receiving a "DHCP Offer" and sending the "DHCP Request". + This fixes a problem with certain DHCP servers that don't + respond 100% of the time to a "DHCP request". E.g. On an + AT91RM9200 processor running at 180MHz, this delay needed + to be *at least* 15,000 usec before a Windows Server 2003 + DHCP server would reply 100% of the time. I recommend at + least 50,000 usec to be safe. The alternative is to hope + that one of the retries will be successful but note that + the DHCP timeout and retry process takes a longer than + this delay. + - CDP Options: CONFIG_CDP_DEVICE_ID @@ -1929,6 +1946,27 @@ Configuration Settings: Scratch address used by the alternate memory test You only need to set this if address zero isn't writeable +- CFG_MEM_TOP_HIDE (PPC only): + If CFG_MEM_TOP_HIDE is defined in the board config header, + this specified memory area will get subtracted from the top + (end) of ram and won't get "touched" at all by U-Boot. By + fixing up gd->ram_size the Linux kernel should gets passed + the now "corrected" memory size and won't touch it either. + This should work for arch/ppc and arch/powerpc. Only Linux + board ports in arch/powerpc with bootwrapper support that + recalculate the memory size from the SDRAM controller setup + will have to get fixed in Linux additionally. + + This option can be used as a workaround for the 440EPx/GRx + CHIP 11 errata where the last 256 bytes in SDRAM shouldn't + be touched. + + WARNING: Please make sure that this value is a multiple of + the Linux page size (normally 4k). If this is not the case, + then the end address of the Linux memory will be located at a + non page size aligned address and this could cause major + problems. + - CFG_TFTP_LOADADDR: Default load address for network file downloads |