diff options
| -rw-r--r-- | cpu/ppc4xx/4xx_enet.c | 17 | ||||
| -rw-r--r-- | include/configs/alpr.h | 2 |
2 files changed, 2 insertions, 17 deletions
diff --git a/cpu/ppc4xx/4xx_enet.c b/cpu/ppc4xx/4xx_enet.c index 8c517ba..7a2483c 100644 --- a/cpu/ppc4xx/4xx_enet.c +++ b/cpu/ppc4xx/4xx_enet.c @@ -560,22 +560,7 @@ static int ppc_4xx_eth_init (struct eth_device *dev, bd_t * bis) * otherwise, just check the speeds & feeds */ if (hw_p->first_init == 0) { -#if defined(CONFIG_88E1111_CLK_DELAY) - /* - * On some boards (e.g. ALPR) the Marvell 88E1111 PHY needs - * the "RGMII transmit timing control" and "RGMII receive - * timing control" bits set, so that Gbit communication works - * without problems. - * Also set the "Transmitter disable" to 1 to enable the - * transmitter. - * After setting these bits a soft-reset must occur for this - * change to become active. - */ - miiphy_read (dev->name, reg, 0x14, ®_short); - reg_short |= (1 << 7) | (1 << 1) | (1 << 0); - miiphy_write (dev->name, reg, 0x14, reg_short); -#endif -#if defined(CONFIG_M88E1111_PHY) /* test-only: merge with CONFIG_88E1111_CLK_DELAY !!! */ +#if defined(CONFIG_M88E1111_PHY) miiphy_write (dev->name, reg, 0x14, 0x0ce3); miiphy_write (dev->name, reg, 0x18, 0x4101); miiphy_write (dev->name, reg, 0x09, 0x0e00); diff --git a/include/configs/alpr.h b/include/configs/alpr.h index 60da820..bbe6b76 100644 --- a/include/configs/alpr.h +++ b/include/configs/alpr.h @@ -187,7 +187,7 @@ #define CONFIG_HAS_ETH2 #define CONFIG_HAS_ETH3 #define CONFIG_PHY_RESET 1 /* reset phy upon startup */ -#define CONFIG_88E1111_CLK_DELAY 1 /* set CLK delay on ALPR */ +#define CONFIG_M88E1111_PHY 1 /* needed for PHY specific setup*/ #define CONFIG_PHY_GIGE 1 /* Include GbE speed/duplex detection */ #define CFG_RX_ETH_BUFFER 32 /* Number of ethernet rx buffers & descriptors */ |