diff options
| -rw-r--r-- | board/freescale/mx6sll_arm2/mx6sll_arm2.c | 8 |
1 files changed, 2 insertions, 6 deletions
diff --git a/board/freescale/mx6sll_arm2/mx6sll_arm2.c b/board/freescale/mx6sll_arm2/mx6sll_arm2.c index 9094586..a07e147 100644 --- a/board/freescale/mx6sll_arm2/mx6sll_arm2.c +++ b/board/freescale/mx6sll_arm2/mx6sll_arm2.c @@ -180,7 +180,7 @@ static void setup_iomux_uart(void) #ifdef CONFIG_FSL_ESDHC static struct fsl_esdhc_cfg usdhc_cfg[CONFIG_SYS_FSL_USDHC_NUM] = { {USDHC1_BASE_ADDR, 0, 8, 1}, - {USDHC2_BASE_ADDR, 0, 8}, + {USDHC2_BASE_ADDR, 0, 8, 0, 1}, /* fixed 1.8v IO voltage for eMMC chip */ {USDHC3_BASE_ADDR, 0, 4}, }; @@ -220,7 +220,7 @@ int board_mmc_getcd(struct mmc *mmc) int board_mmc_init(bd_t *bis) { - int i, ret; + int i; /* * According to the board_mmc_init() the following map is done: @@ -241,10 +241,6 @@ int board_mmc_init(bd_t *bis) imx_iomux_v3_setup_multiple_pads( usdhc2_pads, ARRAY_SIZE(usdhc2_pads)); usdhc_cfg[1].sdhc_clk = mxc_get_clock(MXC_ESDHC2_CLK); - /* eMMC connect to 1.8v, so need to set eMMC I/O voltage to 1.8v */ - ret = readl(usdhc_cfg[1].esdhc_base + 0xc0); /* vend_spec */ - ret |= 0x2; - writel(ret, (usdhc_cfg[1].esdhc_base + 0xc0)); gpio_direction_output(USDHC2_PWR_GPIO, 1); break; case 2: |