summaryrefslogtreecommitdiff
diff options
context:
space:
mode:
-rw-r--r--arch/arm/cpu/armv7/uniphier/Kconfig11
-rw-r--r--arch/arm/cpu/armv7/uniphier/Makefile24
-rw-r--r--arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile13
-rw-r--r--arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile12
-rw-r--r--arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile13
5 files changed, 41 insertions, 32 deletions
diff --git a/arch/arm/cpu/armv7/uniphier/Kconfig b/arch/arm/cpu/armv7/uniphier/Kconfig
index 0556e4b..5c5a84f 100644
--- a/arch/arm/cpu/armv7/uniphier/Kconfig
+++ b/arch/arm/cpu/armv7/uniphier/Kconfig
@@ -50,21 +50,12 @@ endchoice
config CMD_PINMON
bool "Enable boot mode pins monitor command"
- depends on !SPL_BUILD
default y
help
The command "pinmon" shows the state of the boot mode pins.
The boot mode pins are latched when the system reset is deasserted
and determine which device the system should load a boot image from.
-config SOC_INIT
- bool
- default SPL_BUILD
-
-config DRAM_INIT
- bool
- default SPL_BUILD
-
config CMD_DDRPHY_DUMP
bool "Enable dump command of DDR PHY parameters"
depends on !SPL_BUILD
@@ -74,7 +65,7 @@ config CMD_DDRPHY_DUMP
choice
prompt "DDR3 Frequency select"
- depends on DRAM_INIT
+ depends on SPL_BUILD
config DDR_FREQ_1600
bool "DDR3 1600"
diff --git a/arch/arm/cpu/armv7/uniphier/Makefile b/arch/arm/cpu/armv7/uniphier/Makefile
index 713a0d7..df418dd 100644
--- a/arch/arm/cpu/armv7/uniphier/Makefile
+++ b/arch/arm/cpu/armv7/uniphier/Makefile
@@ -2,24 +2,32 @@
# SPDX-License-Identifier: GPL-2.0+
#
-obj-$(CONFIG_SPL_BUILD) += lowlevel_init.o init_page_table.o
-obj-$(CONFIG_SPL_BUILD) += spl.o
+ifdef CONFIG_SPL_BUILD
+
+obj-y += lowlevel_init.o
+obj-y += init_page_table.o
+obj-y += spl.o
+obj-y += ddrphy_training.o
+
+else
-obj-y += timer.o
-obj-y += reset.o
-obj-y += cache_uniphier.o
-obj-y += dram_init.o
-obj-$(CONFIG_DRAM_INIT) += ddrphy_training.o
obj-$(CONFIG_BOARD_EARLY_INIT_F) += board_early_init_f.o
obj-$(CONFIG_DISPLAY_CPUINFO) += cpu_info.o
obj-$(CONFIG_MISC_INIT_F) += print_misc_info.o
+obj-y += dram_init.o
+obj-y += board_common.o
obj-$(CONFIG_BOARD_EARLY_INIT_R) += board_early_init_r.o
obj-$(CONFIG_BOARD_LATE_INIT) += board_late_init.o
+obj-y += reset.o
+obj-y += cache_uniphier.o
obj-$(CONFIG_UNIPHIER_SMP) += smp.o
obj-$(CONFIG_CMD_PINMON) += cmd_pinmon.o
obj-$(CONFIG_CMD_DDRPHY_DUMP) += cmd_ddrphy.o
-obj-y += board_common.o
+endif
+
+obj-y += timer.o
+
obj-$(CONFIG_PFC_MICRO_SUPPORT_CARD) += support_card.o
obj-$(CONFIG_DCC_MICRO_SUPPORT_CARD) += support_card.o
diff --git a/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile b/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile
index bef1b8a..72f4663 100644
--- a/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile
+++ b/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile
@@ -2,10 +2,13 @@
# SPDX-License-Identifier: GPL-2.0+
#
-obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
-obj-y += boot-mode.o
+ifdef CONFIG_SPL_BUILD
obj-$(CONFIG_DEBUG_LL) += lowlevel_debug.o
-obj-$(CONFIG_SOC_INIT) += bcu_init.o sbc_init.o sg_init.o pll_init.o \
- clkrst_init.o
+obj-y += bcu_init.o sbc_init.o sg_init.o pll_init.o clkrst_init.o \
+ pll_spectrum.o umc_init.o ddrphy_init.o
+else
obj-$(CONFIG_BOARD_EARLY_INIT_F) += pinctrl.o
-obj-$(CONFIG_DRAM_INIT) += pll_spectrum.o umc_init.o ddrphy_init.o
+obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
+endif
+
+obj-y += boot-mode.o
diff --git a/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile b/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile
index 484e978..e330fda 100644
--- a/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile
+++ b/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile
@@ -2,9 +2,13 @@
# SPDX-License-Identifier: GPL-2.0+
#
-obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
-obj-y += boot-mode.o
+ifdef CONFIG_SPL_BUILD
obj-$(CONFIG_DEBUG_LL) += lowlevel_debug.o
-obj-$(CONFIG_SOC_INIT) += sbc_init.o sg_init.o pll_init.o clkrst_init.o
+obj-y += sbc_init.o sg_init.o pll_init.o clkrst_init.o \
+ pll_spectrum.o umc_init.o ddrphy_init.o
+else
obj-$(CONFIG_BOARD_EARLY_INIT_F) += pinctrl.o
-obj-$(CONFIG_DRAM_INIT) += pll_spectrum.o umc_init.o ddrphy_init.o
+obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
+endif
+
+obj-y += boot-mode.o
diff --git a/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile b/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile
index bef1b8a..72f4663 100644
--- a/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile
+++ b/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile
@@ -2,10 +2,13 @@
# SPDX-License-Identifier: GPL-2.0+
#
-obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
-obj-y += boot-mode.o
+ifdef CONFIG_SPL_BUILD
obj-$(CONFIG_DEBUG_LL) += lowlevel_debug.o
-obj-$(CONFIG_SOC_INIT) += bcu_init.o sbc_init.o sg_init.o pll_init.o \
- clkrst_init.o
+obj-y += bcu_init.o sbc_init.o sg_init.o pll_init.o clkrst_init.o \
+ pll_spectrum.o umc_init.o ddrphy_init.o
+else
obj-$(CONFIG_BOARD_EARLY_INIT_F) += pinctrl.o
-obj-$(CONFIG_DRAM_INIT) += pll_spectrum.o umc_init.o ddrphy_init.o
+obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
+endif
+
+obj-y += boot-mode.o