ENGR00132909 MX53 Uboot: Support for TO2

Support new DDR script entitled
"Rita_TO2_init_DDR2_CPU2_CMOS_TEST_CAL_v1.inc" for DDR2
boards including MX53 EVK, ARD, and ARM2 CPU2. These new settings
did not apply to TO1. Therefore, changed the DCD
for these boards to a plugin so that TO1 and TO2 can both
be supported using conditional execution of new DDR settings.

During bootup on TO2, DDR frequency is required to be below
400 MHz. Therefore, BOOT_CFG2[4] must be set to enable DDR at
333 MHz in ROM on all boards. Uboot determines silicon version
and for TO2 boosts the VCC and VDDA voltages to 1.3V, after
which the DDR frequency is also increased to 400 MHz.

This requirement meant that uboot does not calibrate PLL2
anymore until the voltage is increased. Removed the calibration
from lowlevel_init.S and from all mx53 include/configs files.
Also required that during config_periph_clk(), only CBCMR register
is touched to set source PLL. Other changes to CBCDR were removed.
Switching to PLL2 bypass clk during reprogram was also removed.
All these changes are required to increase DDR frequency to 400 MHz.

DDR2 CPU2 board with TO1 requires the following hw cfgs:
JP3 populated, and J8 set to 2-3.
For DDR2 CPU2 board with TO2, both these jumpers should be
depopulated.

ARM2 CPU3 (with DDR3) DDR configurations were not changed.
TO1 and TO2 can run well using existing DDR3 script. However,
DCD was converted to plugin to align with other boards.

Signed-off-by: Anish Trivedi <anish@freescale.com>

0 files changed, 0 insertions, 0 deletions