arm/km: enable BOCO2 FPGA download support

This adds a first support of the FPGA download for a PCIe FPGA based
on the BOCO2 CPLD.

This takes place in 3 steps, all done accessing the SPICTRL reg of the
BOCO2:
1) start the FPGA config with an access to the FPGA_PROG bit
2) later in the boot sequence, wait for the FPGA_DONE bit to toggle to 1
   for the end of the FPGA configuration (with a timeout)
3) reset the FPGA
4) finally remove the access to its config EEPROM from the FPGA so that
   the CPU can update the FPGA configuration when the kernel is running

The boards with a PCIe FPGA but without BOCO2 still are supported.

The config option name is CONFIG_KM_FPGA_CONFIG

Signed-off-by: Valentin Longchamp <valentin.longchamp@keymile.com>
Signed-off-by: Holger Brunck <holger.brunck@keymile.com>
cc: Gerlando Falauto <gerlando.falauto@keymile.com>
cc: Prafulla Wadaskar <prafulla@marvell.com>

1 files changed, 5 insertions, 3 deletions

diff --git a/include/configs/km_kirkwood.h b/include/configs/km_kirkwood.h
index 44a3e7a..0a61b7d 100644
--- a/include/configs/km_kirkwood.h
+++ b/include/configs/km_kirkwood.h
@@ -162,10 +162,12 @@
 	MVGBE_SET_MII_SPEED_TO_100)
 #endif
 
-/* GPIO Pin from kirkwood connected to PROGRAM_B pin of the xilinx FPGA */
-#define KM_XLX_PROGRAM_B_PIN    39
-
 #ifdef CONFIG_KM_DISABLE_PCI
 #undef  CONFIG_KIRKWOOD_PCIE_INIT
 #endif
+
+#ifndef CONFIG_KM_FPGA_CONFIG
+#undef  BOARD_LATE_INIT
+#endif
+
 #endif /* _CONFIG_KM_KIRKWOOD */