video: ssd2828: Allow using 'pclk' as the PLL clock source

Instead of using the internal 'tx_clk' clock source, it is also
possible to use the pixel clock signal from the parallel LCD
interface ('pclk') as the reference clock for PLL.

The 'tx_clk' clock speed may be different on different boards/devices
(the allowed range is 8MHz - 30MHz). Which is not very convenient,
especially considering the need to know the exact 'tx_clk' clock
speed. This clock speed may be difficult to identify without having
device schematics and/or accurate documentation/sources every time.

Using 'pclk' is free from all these problems.

Signed-off-by: Siarhei Siamashka <siarhei.siamashka@gmail.com>
Acked-by: Anatolij Gustschin <agust@denx.de>
Acked-by: Hans de Goede <hdegoede@redhat.com>
Signed-off-by: Hans de Goede <hdegoede@redhat.com>

1 files changed, 8 insertions, 3 deletions

diff --git a/drivers/video/ssd2828.h b/drivers/video/ssd2828.h
index 14b96c5..1af6fa4 100644
--- a/drivers/video/ssd2828.h
+++ b/drivers/video/ssd2828.h
@@ -47,8 +47,12 @@ struct ssd2828_config {
 	 * to TX_CLK_XIO/TX_CLK_XIN pins), which is necessary at least for
 	 * clocking SPI after reset. The exact clock speed is not strictly,
 	 * defined, but the datasheet says that it must be somewhere in the
-	 * 8MHz - 30MHz range (see "TX_CLK Timing" section). It is used as
-	 * a reference clock for PLL and must be set correctly.
+	 * 8MHz - 30MHz range (see "TX_CLK Timing" section). It can be also
+	 * used as a reference clock for PLL. If the exact clock frequency
+	 * is known, then it can be specified here. If it is unknown, or the
+	 * information is not trustworthy, then it can be set to 0.
+	 *
+	 * If unsure, set to 0.
 	 */
 	int ssd2828_tx_clk_khz;
 
@@ -115,7 +119,8 @@ struct ssd2828_config {
  * The right place to insert this function call is after the parallel LCD
  * interface is initialized and before turning on the backlight. This is
  * advised in the "Example for system sleep in and out" section of the
- * SSD2828 datasheet.
+ * SSD2828 datasheet. And also SS2828 may use 'pclk' as the clock source
+ * for PLL, which means that the input signal must be already there.
  */
 int ssd2828_init(const struct ssd2828_config *cfg,
 		 const struct ctfb_res_modes *mode);