* Patch by Robin Getz, 13 Oct 2004:

  Add standalone application to change SMC91C111 MAC addresses,
  see examples/README.smc91111_eeprom

* Patch by Xiaogeng (Shawn) Jin, 12 Oct 2004:
  Fix Flash support for ARM Integrator CP.

5 files changed, 10 insertions, 23 deletions

diff --git a/board/omap2420h4/config.mk b/board/omap2420h4/config.mk
index f2a533e..e6aa756 100644
--- a/board/omap2420h4/config.mk
+++ b/board/omap2420h4/config.mk
@@ -20,4 +20,3 @@ TEXT_BASE = 0x80e80000
 # This is either with a GP system or a signed boot image.
 # easiest, and safest way to go if you can.
 #TEXT_BASE = 0x40280000
-
diff --git a/board/omap2420h4/mem.c b/board/omap2420h4/mem.c
index 3ce38cc..9ae595b 100644
--- a/board/omap2420h4/mem.c
+++ b/board/omap2420h4/mem.c
@@ -74,9 +74,9 @@ void prcm_init(void)
 
 	if(running_in_sram()){
 		/* If running fully from SRAM this is OK.  The Flash bus drops out for just a little.
-	 	* but then comes back.  If running from Flash this sequence kills you, thus you need
-	 	* to run it using CONFIG_PARTIAL_SRAM.
-	 	*/
+		* but then comes back.  If running from Flash this sequence kills you, thus you need
+		* to run it using CONFIG_PARTIAL_SRAM.
+		*/
 		__raw_writel(MODE_BYPASS_FAST, CM_CLKEN_PLL); /* go to bypass, fast relock */
 		wait_on_value(BIT0|BIT1, BIT0, CM_IDLEST_CKGEN, LDELAY); /* wait till in bypass */
 		sdelay(1000);
@@ -172,14 +172,13 @@ void do_sdrc_init(u32 offset, u32 early)
 	cpu = get_cpu_type();
 
 	/* warning generated, though code generation is correct. this may bite later,
-         * but is ok for now. there is only so much C code you can do on stack only
-         * operation.
+	 * but is ok for now. there is only so much C code you can do on stack only
+	 * operation.
 	 */
 	if (cpu == CPU_2422){
 		sdata = (sdrc_data_t *)&sdrc_2422;
 		pass_type = STACKED;
-	}
-	else{
+	} else{
 		sdata = (sdrc_data_t *)&sdrc_2420;
 		pass_type = IP_DDR;
 	}
@@ -187,10 +186,10 @@ void do_sdrc_init(u32 offset, u32 early)
 	__asm__ __volatile__("": : :"memory");  /* limit compiler scope */
 
 	/* u-boot is compiled to run in DDR or SRAM at 8xxxxxxx or 4xxxxxxx.
-         * If we are running in flash prior to relocation and we use data
-         * here which is not pc relative we need to get the address correct.
-         * We need to find the current flash mapping to dress up the initial
-         * pointer load.  As long as this is const data we should be ok.
+	 * If we are running in flash prior to relocation and we use data
+	 * here which is not pc relative we need to get the address correct.
+	 * We need to find the current flash mapping to dress up the initial
+	 * pointer load.  As long as this is const data we should be ok.
 	 */
 	if((early) && running_in_flash()){
 		sdata = (sdrc_data_t *)(((u32)sdata & 0x0003FFFF) | get_gpmc0_base());
@@ -344,4 +343,3 @@ void gpmc_init(void)
 	__raw_writel(H4_24XX_GPMC_CONFIG7_1, GPMC_CONFIG7_1); /* enable mapping */
 	sdelay(2000);
 }
-
diff --git a/board/omap2420h4/omap2420h4.c b/board/omap2420h4/omap2420h4.c
index 697dfef..8c7982d 100644
--- a/board/omap2420h4/omap2420h4.c
+++ b/board/omap2420h4/omap2420h4.c
@@ -36,7 +36,6 @@
 extern struct nand_chip nand_dev_desc[CFG_MAX_NAND_DEVICE];
 #endif
 
-
 static void wait_for_command_complete(unsigned int wd_base);
 
 /*******************************************************
@@ -694,8 +693,6 @@ void muxSetupGPMC(void)
 	/* signal - Gpmc_ncs2; pin - E2; offset - 0x008C; mode - 0; Byte-2	Pull/up - N/A */
 	MuxConfigReg = (volatile uint8 *)CONTROL_PADCONF_GPMC_NCS0_BYTE2,
 				   *MuxConfigReg = 0x00 ;
-
-
 }
 
 /****************************************************************
@@ -860,6 +857,3 @@ void nand_init(void)
 #endif
 }
 #endif
-
-
-
diff --git a/board/omap2420h4/platform.S b/board/omap2420h4/platform.S
index 86bf5ba..73ba462 100644
--- a/board/omap2420h4/platform.S
+++ b/board/omap2420h4/platform.S
@@ -183,4 +183,3 @@ VAL_INTH_SETUP:
 	.word PERIFERAL_PORT_BASE
 SRAM_STACK:
 	.word LOW_LEVEL_SRAM_STACK
-
diff --git a/board/omap2420h4/sys_info.c b/board/omap2420h4/sys_info.c
index 78b936c..121d679 100644
--- a/board/omap2420h4/sys_info.c
+++ b/board/omap2420h4/sys_info.c
@@ -251,8 +251,6 @@ static u32 get_base2(void)
 	return(val);
 }
 
-
-
 /********************************************************
  *  running_in_flash() - tell if currently running in
  *   flash.
@@ -302,4 +300,3 @@ u32 running_from_internal_boot(void)
 	else
 		return(0);
 }
-